Ads
related to: radial length for vertical antenna system
Search results
Results From The WOW.Com Content Network
For radials 9 electrical degrees or less ( 1 / 40 wavelength, each, or shorter) the effect on feedpoint impedance and the current in the mast is the same as extending the height of the antenna by a length of wire equal to 99% of the total length of all the radials, up to about a dozen radials.
Buried in the ground under the antenna is an enormous radial ground system, which forms the bottom 'plate' of the capacitor with the overhead top load. The antenna must be very large at the VLF frequencies used; the supporting masts are 250–300 metres (820–980 ft) high, and the topload is about 1,900 metres (6,200 ft) in diameter.
It is shaped like the Greek letter Π or an upside-down capital letter U, and is the loop antenna analog of a ground-mounted monopole antenna. Similar to how a vertical monopole uses its ground system to produce a "phantom" image of the rest of a dipole, the missing lower half of the half-loop is replaced by its image in the ground-plane. If ...
The antenna's feed point is at the center of the disc. It is usually fed with 50-ohm coaxial cable, with the center conductor connected to the disc, and the outer conductor to the cone. The cone: The length of the cone should be a quarter wavelength of the antenna's lowest operating frequency. [2] The cone angle is generally from 25 to 40 degrees.
The gain and input impedance of the antenna is dependent on the length of the whip element, compared to a wavelength, but also on the size and shape of the ground plane used (if any). A quarter wave vertical antenna working against a perfectly conducting, infinite ground will have a gain of 5.19 dBi and a radiation resistance of about 36.8 ohms.
Base-fed mast radiator antennas shorter than about .16 wavelength are not used, [147] as the radiation resistance at that length is around 10 ohms, 5 times the typical resistance of a buried radial ground system, 2 ohms, so in an Earth-grounded antenna over 20% of the transmitter power would be wasted in the ground resistance.
The HB9XBG antenna is a vertical dipole antenna for short wave radio amateurs. It was developed by the Swiss radio amateur Walter Kägi, whose call sign HB9XBG is also the designation of the antenna. [1] During the test phase in 2020, HB9XBG built two vertical dipoles – one for the 20-metre amateur radio band and another for the 40-metre band.
Vertical polarized VHF-UHF biconical antenna 170–1100 MHz with omnidirectional H-plane pattern. Omnidirectional radiation patterns are produced by the simplest practical antennas, monopole and dipole antennas, consisting of one or two straight rod conductors on a common axis.