Ads
related to: tire height calculator rpm rate
Search results
Results From The WOW.Com Content Network
P – these tires are for a passenger vehicle. However 'P' denotes P metric size load and speed rating changes for P tire & non-P tires; 195 – the nominal width of the tire is approximately 195 mm at the widest point; 55 – indicates that the height of the sidewall of the tire is 55% of the width (107 mm) R – this is a radial tire
In (automotive) vehicle dynamics, slip is the relative motion between a tire and the road surface it is moving on. This slip can be generated either by the tire's rotational speed being greater or less than the free-rolling speed (usually described as percent slip), or by the tire's plane of rotation being at an angle to its direction of motion (referred to as slip angle).
Tire uniformity refers to the dynamic mechanical properties of pneumatic tires as strictly defined by a set of measurement standards and test conditions accepted by global tire and car makers. These standards include the parameters of radial force variation , lateral force variation , conicity, ply steer, radial run-out , lateral run-out , and ...
Ride height or ground clearance is the amount of space between the base of an automobile tire and the lowest point of the automobile, typically the bottom exterior of the differential housing (even though the lower shock mounting point may be lower); or, more properly, to the shortest distance between a flat, level surface, and the lowest part ...
The section height of a tire is usually identical to its section width (for tires less than 28 mm, 2.5 mm have to be added to the width to get the height). The overall diameter of the tire is then the rim diameter plus twice the tire's section height. The ISO 5775-1 standard also defines procedures for measuring tires and for calculating from ...
Rotational frequency, also known as rotational speed or rate of rotation (symbols ν, lowercase Greek nu, and also n), is the frequency of rotation of an object around an axis. Its SI unit is the reciprocal seconds (s −1 ); other common units of measurement include the hertz (Hz), cycles per second (cps), and revolutions per minute (rpm).