Search results
Results From The WOW.Com Content Network
An oxygen sensor (or lambda sensor, where lambda refers to air–fuel equivalence ratio, usually denoted by λ) or probe or sond, is an electronic device that measures the proportion of oxygen (O 2) in the gas or liquid being analyzed. [1] It was developed by Robert Bosch GmbH during the late 1960s under the supervision of Günter Bauman. [1]
Fault detection, isolation, and recovery (FDIR) is a subfield of control engineering which concerns itself with monitoring a system, identifying when a fault has occurred, and pinpointing the type of fault and its location. Two approaches can be distinguished: A direct pattern recognition of sensor readings that indicate a fault and an analysis ...
The Ford EEC (Electronic Engine Control) system, which utilized the Toshiba TLCS-12 microprocessor, went into mass production in 1975. [ 7 ] The first Bosch engine management system was the Motronic 1.0 , which was introduced in the 1979 BMW 7 Series (E23) [ 8 ] This system was based on the existing Bosch Jetronic fuel injection system, to ...
The manifold absolute pressure sensor (MAP sensor) is one of the sensors used in an internal combustion engine's electronic control system. Engines that use a MAP sensor are typically fuel injected. The manifold absolute pressure sensor provides instantaneous manifold pressure information to the engine's electronic control unit (ECU).
The ECM is a type of electronic control unit (ECU), which is an embedded system that employs software to determine the required throttle position by calculations from data measured by other sensors, including the accelerator pedal position sensors, engine speed sensor, vehicle speed sensor, and cruise control switches. The electric motor is ...
Some engine control units (ECUs) also control the throttle position by electronic throttle control (ETC) or "drive by wire" systems, and if that is done, the position sensor is used in a feedback loop to enable that control. [1] Related to the TPS are accelerator pedal sensors, which often include a wide open throttle (WOT) sensor.
A fault tree diagram. Fault tree analysis (FTA) is a type of failure analysis in which an undesired state of a system is examined. This analysis method is mainly used in safety engineering and reliability engineering to understand how systems can fail, to identify the best ways to reduce risk and to determine (or get a feeling for) event rates of a safety accident or a particular system level ...
Mono-Jetronic always had adaptive closed-loop lambda control, and due to the simple engine load sensing, it is heavily dependent on the lambda sensor for correct functioning. The ECU uses an Intel 8051 microcontroller , usually with 16 KB of programme memory and without advanced on-board diagnostics (OBD-II became a requirement in model-year 1996.)