Ads
related to: electric gas valve shut off position indicator light switch
Search results
Results From The WOW.Com Content Network
In natural gas furnaces, water heaters, and room heating systems, a safety cut-off switch is normally included so that the gas supply to the pilot and heating system is shut off by an electrically operated valve if the pilot light goes out. This cut-off switch usually detects the pilot light in one of several ways: A flame rectification device. [2]
An example of switch settings could be "Left, Right, Fuselage, Total". This saves room on the instrument panel by negating the need for four different dedicated fuel gauges. Fuel select valve - Connects the fuel flow from the selected tank to the engine. If the aircraft is equipped with a fuel pump:
Valves are actuated by an electric motor, hydraulic fluid or air. For air-operated control valves, electrical signals from the control system are converted to an air pressure for the valve actuator in a current/pneumatic I/P converter. Upon loss of pneumatic or hydraulic pressure valves may fail to an open (FO) or fail to a closed (FC) position.
A shutdown valve (also referred to as SDV or emergency shutdown valve, ESV, ESD, or ESDV; or safety shutoff valve) is an actuated valve designed to stop the flow of a hazardous fluid upon the detection of a dangerous event. This provides protection against possible harm to people, equipment or the environment.
The blue valve body is visible in-line with the pipe. The valve actuator opens or closes the butterfly disc of the valve based on electrical signals sent to the actuator. Another valve actuator is visible in the background, with windows to indicate the valve position. A valve actuator is the mechanism for opening and closing a valve. Manually ...
In some aircraft, the shut-off function is a different valve located after the fuel selector valve. Typically, after the selector valve—situated at a low point in the fuel run—there is a gascolator — a fuel filter that can be opened on the ground and drained of fuel impurities denser than petroleum, mainly water and sediment. Other ...
Switching off an electrically driven gas compressor when a set pressure is achieved in the reservoir; Switching off a gas compressor, whenever there is no feed in the suction stage. in-cell charge control in a battery; Switching on an alarm light in the cockpit of an aircraft if cabin pressure (based on altitude) is critically low.
In its original form, from the 19th century until about 1950, the device usually consisted of a round dial about 9 inches (230 mm) in diameter with a knob at the center attached to one or more handles, and an indicator pointer on the face of the dial. There would also be a revolutions per minute (RPM) indicator, worked by a hand crank. Modern ...