Search results
Results From The WOW.Com Content Network
Crankshaft (red), pistons (gray), cylinders (blue) and flywheel (black) A crankshaft is a mechanical component used in a piston engine to convert the reciprocating motion into rotational motion. The crankshaft is a rotating shaft containing one or more crankpins, [1] that are driven by the pistons via the connecting rods. [2]
From the geometry shown in the diagram above, the following variables are defined: rod length (distance between piston pin and crank pin) crank radius (distance between crank center and crank pin, i.e. half stroke) crank angle (from cylinder bore centerline at TDC)
A crank is an arm attached at a right angle to a rotating shaft by which circular motion ... Reciprocating piston engines use cranks to convert the linear piston ...
A piston is a component of reciprocating engines. It is located in a cylinder and is made gas-tight by piston rings. Its purpose is to transfer force from expanding gas in the cylinder to the crankshaft via a piston rod and/or connecting rod. In two-stroke engines the piston also acts as a valve by covering and uncovering ports in the cylinder ...
A slipper piston is a piston for a petrol engine that has been reduced in size and weight as much as possible. In the extreme case, they are reduced to the piston crown, support for the piston rings, and just enough of the piston skirt remaining to leave two lands so as to stop the piston rocking in the bore.
A connecting rod, also called a 'con rod', [1] [2] [3] is the part of a piston engine which connects the piston to the crankshaft. Together with the crank, the connecting rod converts the reciprocating motion of the piston into the rotation of the crankshaft. [4] The connecting rod is required to transmit the compressive and tensile forces from ...
The crankshaft configuration varies amongst opposed-engine designs. One layout has a flat/boxer engine at its center and adds an additional opposed-piston to each end so there are two pistons per cylinder on each side. An X engine is essentially two V engines joined by a common crankshaft. A majority of these were existing V-12 engines ...
The most common crossplane crankshaft for a 90° V8 engine has four crankpins, each serving two cylinders on opposing banks, offset at 90° from the adjacent crankpins.The first and last of the four crank pins are at 180° with respect to each other as are the second and third, with each pair at 90° to the other, so that viewed from the end the crankshaft forms a cross.