Search results
Results From The WOW.Com Content Network
The negative swing of the output will not dip below about −0.6 V, assuming a silicon PN diode. [1] A clamper (or clamping circuit or clamp) is an electronic circuit that fixes either the positive or the negative peak excursions of a signal to a defined voltage by adding a variable positive or negative DC voltage to it. [2]
The "trick" is that instead of clamping to +5 and GND they clamp to the output of two regulated voltages. This allows the clamping diodes to turn on earlier and is therefore better at eliminating overshoot and undershoot. 1) This text is not part of my submission, only the figure itself is. Rewrite your own summary.
The base diode allows a Si diode clamp to be used with a Si transistor and keeps V CE around a diode drop and much greater than V CE(sat). Unfortunately, it turns off and creates a high-impedance return path when trying to turn the transistor off. Although the base charge has been minimized, it is now more difficult to draw charge out of the base.
Some electronics simulators integrate a schematic editor, a simulation engine, and an on-screen waveform display (see Figure 1), allowing designers to rapidly modify a simulated circuit and see what effect the changes have on the output. They also typically contain extensive model and device libraries.
A simple diode clipper can be made with a diode and a resistor. This will remove either the positive, or the negative half of the waveform depending on the direction the diode is connected. The simple circuit clips at zero voltage (or to be more precise, at the small forward voltage of the forward biased diode) but the clipping voltage can be ...
Diagram of a simple circuit with an inductance L and a flyback diode D.The resistor R represents the resistance of the inductor's windings. A flyback diode is any diode connected across an inductor used to eliminate flyback, which is the sudden voltage spike seen across an inductive load when its supply current is suddenly reduced or interrupted.
Diode logic (or diode-resistor logic) constructs AND and OR logic gates with diodes and resistors. An active device ( vacuum tubes with control grids in early electronic computers , then transistors in diode–transistor logic ) is additionally required to provide logical inversion (NOT) for functional completeness and amplification for voltage ...
Three 1N4148 diodes in glass DO-35 axial package. The black band on the right is the cathode side. Diode schematic symbol vs cathode marking on the package. The 1N4148 is a standard silicon switching signal diode. It is one of the most popular and long-lived switching diodes because of its dependable specifications and low cost.