Search results
Results From The WOW.Com Content Network
A clamper will bind the upper or lower extreme of a waveform to a fixed DC voltage level. These circuits are also known as DC voltage restorers. Clampers can be constructed in both positive and negative polarities. When unbiased, clamping circuits will fix the voltage lower limit (or upper limit, in the case of negative clampers) to 0 volts.
A transient-voltage-suppression diode can respond to over-voltages faster than other common over-voltage protection components such as varistors or gas discharge tubes. The actual clamping occurs in roughly one picosecond, but in a practical circuit the inductance of the wires leading to the device imposes a higher limit. This makes transient ...
A clamper circuit is not a clipper, but the simple diode version has a similar topology to a clipper with the exception that the resistor is replaced with a capacitor. The clamper circuit fixes either the positive or negative peaks at a fixed voltage (determined by the biasing voltage) rather than clipping them off.
English: What it does is use diode clamps to eliminate over and undershoot. The "trick" is that instead of clamping to +5 and GND they clamp to the output of two regulated voltages. This allows the clamping diodes to turn on earlier and is therefore better at eliminating overshoot and undershoot.
The standard two-diode Baker clamp circuit, which includes the feedback current I 1 that reduces the base current I b Baker clamp alternative in a Schottky transistor. The Baker clamp is named after Richard H. Baker, who described it in his 1956 technical report "Maximum Efficiency Transistor Switching Circuits". [2]
If the voltage increases beyond the design limit, the diode goes into avalanche breakdown, causing the harmful voltage to be conducted to ground. When used in this fashion, they are often referred to as clamping diodes or transient-voltage suppressors because they fix or "clamp" the maximum voltage to a predetermined level.
This simple diode clamp will clamp the negative peaks of the incoming waveform to the common rail voltage. A diode clamp circuit can take a periodic alternating current signal that oscillates between positive and negative values, and vertically displace it such that either the positive or the negative peaks occur at a prescribed level. The ...
Diode circuit implementing AND in active-high logic. Note: in analog implementation exact output currents will be different from +5V supply. This circuit mirrors the previous gate: the diodes are reversed so that each input connects to the cathode of a diode and all anodes are connected together to the output, which has a pull-up resistor.