Ads
related to: 15 inch attic exhaust fans with thermostat lowe's wall mounted interior handrails
Search results
Results From The WOW.Com Content Network
An attic fan installed underneath a roof. A powered attic ventilator, or attic fan, is a ventilation fan that regulates the heat level of a building's attic by exhausting hot air. A thermostat is used to automatically turn the fan off and on, while sometimes a manual switch is used. An attic fan can be gable mounted or roof mounted. Additional ...
Ceiling-mounted: Mounted in the ceiling between the attic and living space. Ducted: Remotely mounted away from the ceiling, typically hung from the rafters; can exhaust heat from multiple locations; operation is usually quiet compared to traditional whole-house fans. Window-mounted: Mounted in a window frame. Can also take cool air in from outside.
The rotor of a cross-flow fan is covered to create a pressure differential. A cross-flow fan has two walls outside the impeller and a thick vortex wall inside. The radial gap decreases in the direction of the impeller rotation. The rear wall has a log-spiral profile, while the vortex stabilizer is a thin horizontal wall with a rounded edge. [22]
This column of air moves down and out along the floor. Called a horizontal floor jet, this deep wall of horizontal moving air is relative to the diameter of a fan, and to a lesser degree, the speed of a fan. Once the floor jet reaches its potential, it migrates outward until it meets a side wall or other vertical surface. [8]
The illustration is the interior of a common two wire heat-only household thermostat, used to regulate a gas-fired heater via an electric gas valve. Similar mechanisms may also be used to control oil furnaces, boilers, boiler zone valves , electric attic fans, electric furnaces, electric baseboard heaters, and household appliances such as ...
The wall control, which contains a motor speed regulator of some sort, determines how much power is delivered to the fan and therefore how fast it spins. Older such controls employed a choke—a large iron-cored coil—as their regulator; these controls were typically large, boxy, and surface-mounted on the wall. They had anywhere from four to ...