Ads
related to: what is a pushrod engine system for cars and trucks
Search results
Results From The WOW.Com Content Network
An overhead valve engine, abbreviated (OHV) and sometimes called a pushrod engine, is a piston engine whose valves are located in the cylinder head above the combustion chamber. This contrasts with flathead (or "sidevalve") engines , where the valves were located below the combustion chamber in the engine block .
Pushrods are long, slender metal rods that are used in overhead valve engines to transfer motion from the camshaft (located in the engine block) to the valves (located in the cylinder head). The bottom end of a pushrod is fitted with a lifter, upon which the camshaft makes contact. The camshaft lobe moves the lifter upwards, which moves the ...
As such, push-rod suspension systems allow for much greater high-speed stability, much lower levels of body-roll, and a much lower centre of gravity for the vehicle. [7] For pull-rod suspension systems, the only difference is the orientation of the rocker arms. In a push-rod system, the rocker arms are placed at the highest point in the assembly.
The engine was discontinued in 2003, replaced by the 2.2-liter DOHC Ecotec engine. Although it displaces 134 cu. in, the 2.2-liter OHV is still commonly referred to as the GM 122 today, and has been reputed for its simplicity, reliability, and ease of maintenance in the J-body cars and S-series trucks, and a few L-body cars.
The Nissan H series of automobile engines is an evolution of the Nissan "R" engine which was based on the 1.5-liter, three-main bearing "G" engine used in the 1960s. Both inline-four and inline-six versions were produced. It is a pushrod OHV design with iron block, early models with an iron head, later models with aluminum head.
The most common use of a rocker arm is to transfer the motion of a pushrod in an overhead valve (OHV) internal combustion engine to the corresponding intake/exhaust valve. In an OHV engine the camshaft at the bottom of the engine pushes the pushrod upwards. The top of the pushrod presses upwards on one side of the rocker arm located at the top ...
The Viper engine is a high-performance naturally-aspirated pushrod 2 valve-per-cylinder 90° V10 engine designed by Chrysler but with aluminum block castings designed by Lamborghini for use in the Dodge Viper. Despite its large displacement, it is based on the Chrysler LA V8.
The Chevrolet Inline-4 engine was one of Chevrolet's first automobile engines, designed by Arthur Mason and introduced in 1913. Chevrolet founder Billy Durant, who previously had owned Buick which had pioneered the overhead valve engine, used the same basic engine design for Chevrolet: exposed pushrods and rocker arms which actuated valves in the detachable crossflow cylinder head.