When.com Web Search

  1. Ads

    related to: 15 gallon x 8 outlet hose clamps

Search results

  1. Results From The WOW.Com Content Network
  2. Hose clamp - Wikipedia

    en.wikipedia.org/wiki/Hose_clamp

    The hose is then fit onto the barb, the clamp expanded again, slid onto the portion of the hose over the barb, then released, compressing the hose onto the barb. Clamps of this design are rarely used for high pressures or large hoses, as they would require unwieldy amounts of steel to generate enough clamping force, and be impossible to work ...

  3. Glossary of firefighting equipment - Wikipedia

    en.wikipedia.org/wiki/Glossary_of_firefighting...

    A Cooper hose jacket is a clamping device made out of metal, and is designed to clamp around leaking or burst hose sections. It can also be used to connect two hoses with incompatible couplings, e.g. different threads or sizes.

  4. Riser clamp - Wikipedia

    en.wikipedia.org/wiki/Riser_clamp

    Riser clamp for a standpipe through-penetration firestop inside a fire hose cabinet under construction. A riser clamp is a type of hardware used by mechanical building trades for pipe support in vertical runs of piping (risers) at each floor level. The devices are placed around the pipe, and integral fasteners are then tightened to clamp them ...

  5. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    These pipe clamps are similar to hose clamps, but are heavier-duty and ideally are made completely of stainless steel (including the screw) to provide maximum service life. [ 21 ] : 149 [ 18 ] : 71 Optionally, the entire rubber sleeve may be jacketed with thin sheet metal, to provide extra stiffness, durability, and resistance to accidental ...

  6. Compression fitting - Wikipedia

    en.wikipedia.org/wiki/Compression_fitting

    A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect

  7. Scuba cylinder valve - Wikipedia

    en.wikipedia.org/wiki/Scuba_cylinder_valve

    232 bar DIN (5-thread, G5/8) Outlet/Connector #13 to DIN 477 part 1 - (technically they are specified for cylinders with 300 bar test pressure) [21] 300 bar DIN (7-thread, G5/8) Outlet/Connector #56 to DIN 477 part 5 - these are similar to 5-thread DIN fitting but are rated to 300 bar working pressures.