When.com Web Search

  1. Ads

    related to: dana 60 locker front hub seal on john deere 4310

Search results

  1. Results From The WOW.Com Content Network
  2. Dana 60 - Wikipedia

    en.wikipedia.org/wiki/Dana_60

    The Dana/Spicer Model 60 is an automotive axle manufactured by Dana Holding Corporation and used in OEM pickup and limited passenger car applications by Chevrolet, Dodge, Chrysler, Jeep, Ford and Land Rover. There are front and rear versions of the Dana 60.

  3. List of John Deere tractors - Wikipedia

    en.wikipedia.org/wiki/List_of_John_Deere_tractors

    John Deere Model 60 (1955) John Deere Model 530 (1959) John Deere Model 430S (circa 1960) After years of testing, Deere & Company released its first proper diesel engined tractor in 1949, the Model R. The R was also the first John Deere tractor with a live independent power take-off (PTO) equipped with its own clutch. The R also incorporated ...

  4. Locking hubs - Wikipedia

    en.wikipedia.org/wiki/Locking_hubs

    The benefits of unlocking hubs for normal road use are mainly found in increased fuel efficiency. When the front hubs are locked, even if no power is sent to the front axle (by means of a transfer case), the turning of the wheels will still spin the front axle, differential, and driveshaft, which puts extra load on the engine. Unlocking the ...

  5. Dana Incorporated - Wikipedia

    en.wikipedia.org/wiki/Dana_Incorporated

    Dana Incorporated is an American supplier of axles, driveshafts, and electrodynamic, thermal, sealing, and digital equipment for conventional, hybrid, and electric-powered vehicles. The company's products and services are aimed at the light vehicle, commercial vehicle, and off-highway equipment markets.

  6. Dana 44 - Wikipedia

    en.wikipedia.org/wiki/Dana_44

    Dana 44 Front axles were known for utilizing locking hubs or a center axle disconnect system. However, a permanently locked-in Dana 44 is not uncommon. The Dana 44 has seen use in 1/4-, 1/2-, 3/4-, and 1-ton rated trucks. The Dana 44 was manufactured in kingpin and ball joint variations, as well as closed and open knuckle variations.

  7. Dana 80 - Wikipedia

    en.wikipedia.org/wiki/Dana_80

    Dana 80's are made as full floating, rear axles only and are a step up in overall strength compared to the Dana 70. 1988 Ford was the first company to use the Dana 80. The Dana 80 has a GAWR up to 11,000 pounds (5,000 kg), however it is common practice among manufacturers to derate Dana 80's. Gross axle weight ratings are lowered by the vehicle ...