Search results
Results From The WOW.Com Content Network
Consider a Yagi–Uda consisting of a reflector, driven element, and a single director as shown here. The driven element is typically a 1 ⁄ 2 λ dipole or folded dipole and is the only member of the structure that is directly excited (electrically connected to the feedline). All the other elements are considered parasitic. That is, they ...
A folded dipole is, technically, a folded full-wave loop antenna, where the loop has been bent at opposing ends and squashed into two parallel wires in a flat line. Although the broad bandwidth, high feedpoint impedance, and high efficiency are characteristics more similar to a full loop antenna, the folded dipole's radiation pattern is more ...
Adding a director to this, to give a 3 element Yagi, gives a gain of about 7 dB over a dipole. As a rule of thumb, each additional parasitic element beyond this adds about 1 dB of gain. [2] In an example of a parasitic element that is not rod-shaped, a parasitic microstrip patch antenna is sometimes mounted above another driven patch antenna ...
It is a two element Yagi-Uda antenna with folded dipole elements, and no director(s). Because of the folded ends, the element lengths are approximately 70% of the equivalent dipole length. The two-element design gives modest directivity (about 2.0 dB ) with a null towards the rear of the antenna, yielding a high front-to-back ratio : Gain up to ...
A turnstile antenna, or crossed-dipole antenna, [1] is a radio antenna consisting of a set of two identical dipole antennas mounted at right angles to each other and fed in phase quadrature; the two currents applied to the dipoles are 90° out of phase. [2] [3] The name reflects the notion the antenna looks like a turnstile when mounted ...
A common example is to run the entire calculation suite for different input frequencies, and then plot samples on a single chart. One might use this to sample through the UHF television frequencies, for instance, producing a diagram that illustrates the gain across the band. Another common feature is an iterative solver that adjusts a given ...
The Yagi and the LPDA designs look very similar at first glance, as they both consist of a number of dipole elements mounted along a support boom. The Yagi, however, has only a single driven element connected to the transmission line, usually the second one from the back of the array, the remaining elements are parasitic. The Yagi antenna ...
Corner reflector UHF TV antenna from 1954 with bowtie dipole driven element. A corner reflector antenna is a type of directional antenna used at VHF and UHF frequencies. [1] [2] It was invented by John D. Kraus in 1938. [3] [4] It consists of a dipole driven element mounted in front of two flat rectangular reflecting screens joined at an angle ...