Search results
Results From The WOW.Com Content Network
The DW-link uses anti-squat to eliminate "suspension bob." Squat is defined as the tendency of rear suspension to compress under acceleration. The anti-squat used in the DW-link system is achieved by a minimisation of torque about the centre of mass. The DW-link system has also been designed to minimise pedal feedback caused by suspension travel.
Six-bar linkage from Kinematics of Machinery, 1876. In mechanics, a six-bar linkage is a mechanism with one degree of freedom that is constructed from six links and seven joints. [1] An example is the Klann linkage used to drive the legs of a walking machine. In general, each joint of a linkage connects two links, and a binary link supports two ...
A chain drive and rear derailleur gear change, the most popular system in use today A shaft-drive with crankset and rear gear hub. Bicycle drivetrain systems are used to transmit power on bicycles, tricycles, quadracycles, unicycles, or other human-powered vehicles from the riders to the drive wheels.
This was followed by various eastern European tractors through the 1970s (using manual operation via a single clutch pedal), then the Porsche 962 C racing car in 1985. The first DCT of the modern era was used in the 2003 Volkswagen Golf R32. Since the late 2000s, DCTs have become increasingly widespread, and have supplanted hydraulic automatic ...
Watt's linkage automobile suspension Watt's linkage train suspension. Watt's linkage is used in the rear axle of some car suspensions as an improvement over the Panhard rod, which was designed in the early twentieth century. Both methods are intended to prevent relative sideways motion between the axle and body of the car.
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
A linkage between these hubs pivots the two wheels together, and by careful arrangement of the linkage dimensions the Ackermann geometry could be approximated. This was achieved by making the linkage not a simple parallelogram, but by making the length of the track rod (the moving link between the hubs) shorter than that of the axle, so that ...
The Maybach system is essentially a simplified version of the double differential, or more accurately in mechanical terms, a double controlled differential. It replaces the double differential's forward and reverse steering shaft and clutch system with a single shaft that spins in one direction, and brakes on the idlers.