Ads
related to: 4r75e transmission dipstick tube clamp torque
Search results
Results From The WOW.Com Content Network
While there is some speculation that the 70 can be multiplied by ten to indicate the pound-feet of torque this transmission is capable of handling, including torque converter multiplication, (i.e. 700 lb-ft of torque), there is no reliable source indicating this. In fact, a Ford document stated that the 2003 "Expedition's 4R70W transmission is ...
2018–present 8F24 8-speed transverse transmission (1.0 and 1.5 EcoBoost) Ford Focus; 2018–present 8F57 8-speed transverse transmission for higher torque (2.7 V6 EcoBoost) Ford Edge ST, Ford Explorer, Ford Fusion, Ford Taurus; 2020–present 8F SelectShift® 8-speed transverse transmission (2.0 and 2.3 EcoBoost) Lincoln Corsair, Lincoln ...
The torque tube design is typically heavier and securely ties the rear end together, thus providing a rigid rear end and assuring good alignment under all conditions. However, because of the greater unsprung weight of the torque tube and radius rods, there may be a "little hopping around of the rear end when cornering fast or on washboard roads ...
The 6R 80 features "Filled for Life" low viscosity synthetic transmission fluid (MERCON LV), though a fluid flush is recommended at 150,000 mi (241,000 km) if your truck falls under the classification of "Severe Duty" operation. The transmission, as used in the Ford F-150, has a fluid capacity of 13.1 US qt (12.4 L) and weighs 215 lb (98 kg).
Beginning in 1998 a new 300mm torque converter with improved higher-capacity internals, 300mm style input shaft, and 300mm style pump was also introduced on models coupled to a Gen III Small Block. The 4L60E is rated to handle up to 360 ft⋅lb (490 N⋅m) of torque. It weighs 133 pounds without transmission fluid. [1]
This same transmission is used in the Saturn Vue Green Line hybrid vehicle with the addition of an auxiliary oil pump and hybrid-aware electronics. It is designed for 3.0–3.5 L engines producing up to 205 ft·lbf (278 N·m) of torque, but was also commonly mated to some versions of GM's 4-cylinder Ecotec line.
The TH400 was phased out for the 1980 models, when the A-727 replaced the TH-400 as the only automatic transmission option for both the SJ Wagoneer/Cherokee wagons and the J-10/J-20 trucks. Internally similar to the Chrysler A-727, the case was one-piece, cast with an AMC pattern bellhousing (not interchangeable with a Chrysler pattern A-727).
The 3-valve 5.4L and 4.6L V8s were mated to Ford's new 6R80E 6-speed automatic transmission, while the 4R75E 4-speed automatic transmission was carried over for the 2-valve 4.6L V8. The 4.2L OHV V6 engine was dropped because of the closure of the Essex engine plant where it was produced.