Search results
Results From The WOW.Com Content Network
In the bipolar transistor example, it is the ratio of the output current to the input current, both measured in amperes. In the case of other devices, the gain will have a value in SI units. Such is the case with the operational transconductance amplifier , which has an open-loop gain ( transconductance ) in siemens ( mhos ), because the gain ...
This is more commonly used than scalar linear gain and a positive quantity is normally understood as simply a "gain", while a negative quantity is a "negative gain" (a "loss"), equivalent to its magnitude in dB. For example, at 100 MHz, a 10 m length of cable may have a gain of −1 dB, equal to a loss of 1 dB.
Another useful characteristic is the common-base current gain, α F. The common-base current gain is approximately the gain of current from emitter to collector in the forward-active region. This ratio usually has a value close to unity; between 0.980 and 0.998. It is less than unity due to recombination of charge carriers as they cross the ...
In other words, the circuit has current gain (which depends largely on the h FE of the transistor) instead of voltage gain. A small change to the input current results in much larger change in the output current supplied to the output load. One aspect of buffer action is transformation of impedances.
Current gain in the common emitter circuit is obtained from the base and the collector circuit currents. Because a very small change in base current produces a large change in collector current, the current gain (β) is always greater than unity for the common-emitter circuit, a typical value is about 50.
A Darlington pair behaves like a single transistor, meaning it has one base, collector, and emitter. It typically creates a high current gain (approximately the product of the gains of the two transistors, because their β values multiply together). A general relation between the compound current gain and the individual gains is given by:
The BC548 is available in three different gain groups:. "A" indicates low gain (110 to 220, typically 180) at 2 mA collector current, "B" indicates medium gain (200 to 450) "C" indicates high gain (420 to 800) So a BC548 might have a current gain anywhere between 110 and 800, but the gain of a BC548A would be within the range of 110 to 220.
The transistor is not needed if the required current doesn't exceed the sourcing ability of the op-amp. The article on current mirror discusses another example of these so-called gain-boosted current mirrors. Figure 8: Constant current source using the LM317 voltage regulator