Search results
Results From The WOW.Com Content Network
An older, but still widely used, high-leg delta system uses three phases with 240 volts phase-to-phase for motor loads, and 120 volts for lighting loads by use of a center-tapped transformer; two of the phases are 120 volts to neutral. The third phase, the "high leg" of the system (also referred to as the "wild leg"), has 208 V to neutral and ...
An open (single envelope) CFL [12] An encapsulated/closed (double envelope) CFL. Some fluorescent lamps emit ultraviolet radiation. [citation needed] The Health Protection Agency of the United Kingdom has conducted research concluding that exposure to open (single envelope) compact fluorescent lamps (CFLs) for over 1 hour per day at a distance of less than 30 cm can exceed guideline levels as ...
The cathode is the negative electrode. Any gas-discharge lamp has a positive (anode) and a negative electrode. Both electrodes alternate between acting as an anode and a cathode when these devices run with alternating current. A standard computer case fitted with blue and green cold-cathode tubes Cold-cathode fluorescent lamp backlight
A lamp cord (also known as a zip cord) is a light-weight, ungrounded, single-insulated two-wire cord used for small loads such as a table or floor lamp. A cord set includes connectors molded to the cord at each end (see Appliance coupler). Cord sets are detachable from both the power supply and the electrical equipment, and consist of a ...
An electric light, lamp, or light bulb is an electrical component that produces light.It is the most common form of artificial lighting.Lamps usually have a base made of ceramic, metal, glass, or plastic which secures the lamp in the socket of a light fixture, which is often called a "lamp" as well.
Falls from ladders are very common among the elderly, especially men, with potentially worse injuries owing to the greater heights involved. Fall prevention is thus an important consideration in designing homes for the elderly, and one of the most critical parts of that design process is supplying strong and effective lighting. Thus, when ...
Neutral is a circuit conductor that normally completes the circuit back to the source. NEC states that the neutral and ground wires should be connected at the neutral point of the transformer or generator, or otherwise some "system neutral point" but not anywhere else. [1]
Even worse, if the ground screw of the receptacle is connected to the neutral side, electric shock is possible even when the appliance is properly functioning. This is called a "false" or "bootleg" ground and is a serious safety hazard [ 10 ] : 49 often undetected by common receptacle testers .