Search results
Results From The WOW.Com Content Network
390 FE V8 in a 1969 Ford Mustang. The 390 had a bore of 4.05 inches (102.87 mm), stroke of 3.785 inches (96.14 mm), and displacement of 390.04 cu in (6.4 L). It was the most common FE engine in later applications; used in many Ford cars as the standard engine, including the Thunderbird, and in many trucks as well.
Later models came with hydraulic clutches. These were commonly found in Pintos, some Mustang II/Capris, and Rangers but do not match the V6 Bell housings. Changing the engine to a V6 often requires changing the bellhousing (Mitsubishi) but the Mazda trans had an integral bell. 2.6, 2.8, 2.9, and 2.9 Cosworth. Most of these were RWD car engines.
Although 1969 continued with many of the same basic V8 engines available on 1968 models, notably a revised 302 cu in (4.9 L) small block engine with 220 hp (164 kW; 223 PS), the 390 cu in (6.4 L) FE with 320 hp (239 kW; 324 PS) and the recently launched 428 cu in (7.0 L) Cobra Jet engine (with or without Ram-Air) with an advertised 335 hp (250 ...
The largest-displacement 385 engine, the 460 was developed as the successor for the 462 MEL V8 and the 390 FE/FT V8. It shared a 4.36-inch bore with the 429 but the 460 was designed with a 3.85-inch stroke. For 1968, it was introduced in the Continental Mark III and availability was exclusive to Lincolns until 1971. In 1972, the engine was ...
The K-code HiPo engine was an expensive option and its popularity was greatly diminished after the 390 and 428 big-block engines became available in the Mustang and Fairlane lines, which offered similar power (at the expense of greater weight, and worsened front/rear weight distribution) with cheaper parts at far less cost.
For the 1971 model year, Ford introduced the 400 V8 engine as a replacement for the 390 V8. [5] [19] Ford billed the 400 as the 351C's big brother. It was designed to provide brisk acceleration in medium to heavy weight vehicles in an engine package that was smaller and lighter than the FE V8 Engines and the 385 Series Ford V8's. [20]
The 1965 and later engines can be identified by four core plugs and the casting code C5DE-H. The 1965 Mustang (August 1964 onward) used this engine as standard, rated at 120 hp (89 kW). The Mustang continued to use the 200 as its base engine until it was dropped in 1971. Starting in 1966, a six-bolt bellhousing flange block was introduced ...
The first Y-block on Ford automobiles and F100 trucks was the 239 cu in (3,910 cc) version as released in 1954 with EBU casting numbers. The Y-block was the same displacement as the old Ford Flathead V8 that it replaced but with a bigger bore and a shorter stroke (3.5 x 3.1 in).