Ads
related to: nd yag pulsed mode
Search results
Results From The WOW.Com Content Network
However, there are also transitions near 946, 1120, 1320, and 1440 nm. Nd:YAG lasers operate in both pulsed and continuous mode. Pulsed Nd:YAG lasers are typically operated in the so-called Q-switching mode: An optical switch is inserted in the laser cavity waiting for a maximum population inversion in the neodymium ions before it opens. Then ...
Mostly used for pulsed pumping of certain types of pulsed Ti:sapphire lasers, combined with frequency doubling. Neodymium-doped yttrium orthovanadate (Nd:YVO 4) laser 1.064 μm laser diode Mostly used for continuous pumping of mode-locked Ti:sapphire or dye lasers, in combination with frequency doubling. Also used pulsed for marking and ...
Pulsed Nd:YAG and Er:YAG lasers are used in laser tattoo removal and laser range finders among other applications. Pulsed lasers are also used in soft-tissue surgery. When a laser beam comes into contact with soft-tissue, one important factor is to not overheat surrounding tissue, so necrosis can be prevented. [3]
For example, as well as the principal 1,064 nm output line, Nd:YAG has weaker transitions at wavelengths of 1,052 nm, 1,074 nm, 1,112 nm, 1,319 nm, and a number of other lines. [6] Usually, these lines do not operate unless the gain of the strongest transition is suppressed, such as by use of wavelength-selective dielectric mirrors .
Nd:YAG lasers can operate in both pulsed and continuous mode, but the other types are limited to pulsed mode. The original and still popular solid-state design is a single crystal shaped as a rod approximately 20 mm in diameter and 200 mm long, and the ends are ground flat. This rod is surrounded by a flash tube containing xenon or krypton ...
[citation needed] A Q-switched Nd:YAG laser normally has pulse duration in the order of nanoseconds, peak power on the order of ten to hundreds of MW/cm 2, and a material removal rate of a few micrometers per pulse. A flash lamp pumped Nd:YAG laser normally has a pulse duration on the order of hundreds of microseconds to a millisecond, peak ...
Q-switching, sometimes known as giant pulse formation or Q-spoiling, [1] is a technique by which a laser can be made to produce a pulsed output beam. The technique allows the production of light pulses with extremely high peak power, much higher than would be produced by the same laser if it were operating in a continuous wave (constant output) mode.
A pulse-forming network for an Nd:YAG laser rangefinder The Shiva Star device at Air Force Research Laboratory, USA, which generates pulsed power for high-energy fusion power experiments. Each of the 6 radial arms is a pulse-forming line delivering a pulse of energy to the center, whose capacitors store a total of 10 MJ of energy and can create ...