Ads
related to: jaguar irs rear suspension kit for 1980 corvette specifications specs diagram
Search results
Results From The WOW.Com Content Network
4] The complete rear suspension assembly is carried in a steel crossbeam cradle (shown ghosted in the diagram below), which is attached to the vehicle body via four rubber vee-blocks and also carries the differential (blue) and inboard brakes (red). The rear wheels are located transversely by top links and wheel carriers (green) and lower links ...
This axle is referred to as a Dana 44 ICA or Dana 44 IRS. All 1980–1982 Chevrolet Corvette C3 and manual transmission equipped 1985–1996 Chevrolet Corvette C4 had this axle. The 2005–06 Pontiac GTO, The Dodge Viper has always used a Dana 44 IRS setup. The majority of Corvette and Viper Dana 44 IRS set ups use a limited slip differential.
The Herald, Vitesse, Spitfire, and GT6 all used a rear transverse leaf spring, as well as the 1995-98 Volvo 960/S90/V90 and a rare Swedish sports car incorporating the Volvo 960 rear suspension called the JC Indigo. [1]: 4 This type of suspension should not be confused with earlier, rigid axle applications such as those used on early Ford cars.
The C5 Corvette's rear suspension. The leaf-spring suspension configuration is independent, because the movement of one wheel is not determined by the position of the other. [6] Control arms are utilized to define the motion of the wheel as the suspension is compressed. The usual coil springs are replaced with a single FRP spring, which spans ...
The 2016 all wheel drive version of the Fiat 500X crossover based on the Jeep Renegade uses multi-link Chapman strut suspension at the rear, with MacPherson struts at the front. [ 25 ] [ 26 ] [ iii ] Although the driveshafts are a suspension link, making this a Chapman strut, there are additional transverse links as well.
An active suspension is a type of automotive suspension that uses an onboard control system to control the vertical movement of the vehicle's wheels and axles relative to the chassis or vehicle frame, rather than the conventional passive suspension that relies solely on large springs to maintain static support and dampen the vertical wheel movements caused by the road surface.
Automotive suspension design is an aspect of automotive engineering, concerned with designing the suspension for cars and trucks. Suspension design for other vehicles is similar, though the process may not be as well established. The process entails Selecting appropriate vehicle level targets; Selecting a system architecture
The rear-engined 1960-69 Chevrolet Corvair Z-body up to 1964 used a variation of the rear swing-axle suspension and a transaxle similar to that found on the 1961-63 Pontiac Tempest. The 1961-62 Corvair station wagons even utilized a roofline similar to that on the 1961-63 Y-body wagons.