Ads
related to: intel standard sata ahci controller windows 10wiki-drivers.com has been visited by 100K+ users in the past month
Search results
Results From The WOW.Com Content Network
Some operating systems, notably Windows Vista, Windows 7, Windows 8, Windows 8.1 and Windows 10, do not configure themselves to load the AHCI driver upon boot if the SATA controller was not in AHCI mode at the time the operating system was installed. Although this is an easily rectifiable condition, it remains an ongoing issue with the AHCI ...
It contains two operation modes that follow two Intel specific modes rather than the SATA standard. The name modes and the application that contains them have been renamed since the first version. Until 2010 it contains AHCI and Matrix RAID modes. The first mode is the Intel driver SATA normal and the latter mode is a fake RAID. [1]
When enabled via the AHCI controller, this allows the SATA host bus adapter to enter a low-power state during periods of inactivity, thus saving energy. The drawback to this is increased periodic latency as the drive must be re-activated and brought back on-line before it can be used, and this will often appear as a delay to the end-user.
[4] [5] Linux kernels support AHCI natively since version 2.6.19, and FreeBSD fully supports AHCI since version 8.0. Windows Vista and Windows 7 also natively support AHCI, but their AHCI support (via the msahci service) must be manually enabled via registry editing if controller support was not present during their initial install.
A 3.5-inch Serial ATA hard disk drive A 2.5-inch Serial ATA solid-state drive. SATA was announced in 2000 [4] [5] in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing ...
The ATA standard is supported by both parallel (IDE, PATA) and serial (SATA) ATA hardware. A drawback of the original ATA TRIM command is that it was defined as a non-queueable command and therefore could not easily be mixed with a normal workload of queued read and write operations. SATA 3.1 introduced a queued TRIM command to remedy this. [70]
There are three options available for the logical device interfaces and command sets used for interfacing with storage devices connected to a SATA Express controller: [6] [8] Legacy SATA Used for backward compatibility with legacy SATA devices, and interfaced through the AHCI driver and legacy SATA 3.0 (6 Gbit/s) ports provided by a SATA ...
Intel i945GC northbridge with Pentium Dual-Core microprocessor. This article provides a list of motherboard chipsets made by Intel, divided into three main categories: those that use the PCI bus for interconnection (the 4xx series), those that connect using specialized "hub links" (the 8xx series), and those that connect using PCI Express (the 9xx series).