Search results
Results From The WOW.Com Content Network
Under visual meteorological conditions, the minimum visual range, distance from clouds, or cloud clearance requirements to be maintained above ground vary by jurisdiction, and may also vary according to the airspace in which the aircraft is operating. [4] In some countries, VFR flight is permitted at night, and is known as night VFR.
The flight should climb to and maintain 5000 feet initially, and further clearance to FL330 may be expected (but is not guaranteed) ten minutes after departure. The frequency to which the crew should tune after departure is 124.50 MHz, and the transponder should be set to 6562 before departure.
VFR / VMC visibility requirements in the US In aviation , visual meteorological conditions ( VMC ) is an aviation flight category in which visual flight rules (VFR) flight is permitted—that is, conditions in which pilots have sufficient visibility to fly the aircraft maintaining visual separation from terrain and other aircraft.
Maximum elevation figure (MEF) is a type of visual flight rule (VFR) information that indicates the elevation of the highest geographical feature within a GEOREF quadrangle area. It is of interest to pilots, who want to be aware of the highest mountain peaks and tall towers nearby, so that they can fly above them to avoid controlled flight into ...
VFR visibility and cloud clearance requirements are the same as for class C and D airspaces when below 10,000 feet (3,000 m) MSL. Above 10,000 ft MSL, the visibility requirement is extended to 5 miles (8 km) and the cloud clearance requirement is extended to 1,000 feet (300 m) below clouds, 1,000 feet (300 m) above, and 1 mile (1.6 km) laterally.
VFR over-the-top is different from VFR-on-top, in that VFR-on-top is an IFR clearance that allows the pilot to fly VFR altitudes, while VFR over-the-top is strictly a VFR operation in which the pilot maintains VFR cloud clearance requirements while operating on top of an undercast layer. [2]
Upon each landing, depending on the runway distance remaining, aircraft and pilot capabilities, noise abatement procedures in effect, and air traffic control clearance, the pilot will perform either a full stop landing (taxi to the runway beginning for subsequent take-off), a touch-and-go (stabilize in the landing roll, reconfigure the aircraft ...
In United States aviation, a sectional aeronautical chart, often called a sectional chart or a sectional for short, is a type of aeronautical chart designed for air navigation under visual flight rules (VFR). In Australia, Canada and some other countries, the equivalent charts used for visual flight are called VFR Navigation Charts (VNCs).