When.com Web Search

  1. Ads

    related to: phillips pan head screw dimensions chart

Search results

  1. Results From The WOW.Com Content Network
  2. List of screw drives - Wikipedia

    en.wikipedia.org/wiki/List_of_screw_drives

    In Japan, the male sizes are often designated as DTC-20, DTC-27, DTC-40 (discontinued) and DTC-45 corresponding to a respective screw head size of 3.2 mm, 4.6 mm, 6.4 mm and 7.7 mm; with the size of the screw measured across the widest portion of the mating part of the head. The most common sizes in use for consumer electronics are DTC-20 and ...

  3. List of screw and bolt types - Wikipedia

    en.wikipedia.org/wiki/List_of_screw_and_bolt_types

    In 1913, Woolley and Meredith defined them like Anthony, but gave the following dimensions: hex head cap screws up to and including 7 ⁄ 16 inch (11.1125 mm) have a head that is 3 ⁄ 16 inch (4.7625 mm) larger than the shank diameter; screws greater than 1 ⁄ 2 inch (12.7 mm) in diameter have a head that is 1 ⁄ 4 inch (6.35 mm) larger than ...

  4. Screw - Wikipedia

    en.wikipedia.org/wiki/Screw

    An assortment of screws, and a US quarter for size comparison A wood screw: a) head; b) non-threaded shank; c) threaded shank; d) tip The six classical simple machines. A screw is an externally helical threaded fastener capable of being tightened or released by a twisting force to the head.

  5. Robertson screw - Wikipedia

    en.wikipedia.org/wiki/Robertson_screw

    Many screws used in electrical applications (for example, a typical NEMA 5-15R, breaker screws, and conduit screws) use a combination of a slotted/Phillips/Robertson screw head. A few tool manufacturers make bits to engage this screw head better than the traditional Phillips allowing for more torque before camout, for example, the C1 and C2 ...

  6. Computer case screws - Wikipedia

    en.wikipedia.org/wiki/Computer_case_screws

    All three patterns may also be combined with a slot for a flat-blade screwdriver. Usually they are provided with a 1/4 in (0.25 inches (6.4 mm)) flanged hex head. Non-standard metricized 5.5 millimetres (0.22 in) flanged hex heads can also be encountered. Also common are pan head screws - a low disk with a chamfered outer edge.

  7. File:Screw Head - Slotted-Phillips (pan head, black oxide).jpg

    en.wikipedia.org/wiki/File:Screw_Head_-_Slotted...

    Screw_Head_-_Slotted-Phillips_(pan_head,_black_oxide).jpg (800 × 450 pixels, file size: 42 KB, MIME type: image/jpeg) This is a file from the Wikimedia Commons . Information from its description page there is shown below.

  1. Ad

    related to: phillips pan head screw dimensions chart