Search results
Results From The WOW.Com Content Network
Top and side view of a typical manual transmission, in this case, a Ford Toploader, used in vehicles with external floor shifters. The first car to use a manual transmission with synchromesh was the 1929 Cadillac. [5] Most North American marques had adopted synchronized manual transmissions, usually for second and high gears, by the mid-1930s.
A two-wheel drive vehicle has two driven wheels, typically both at the front or back, while a four-wheel drive has four. A steering wheel is a wheel that turns to change the direction of a vehicle. A trailer wheel is one that is neither a drive wheel, nor a steer wheel. Front-wheel drive vehicles typically have the rear wheels as trailer wheels.
Most early automobiles were rear-engined, using a single-speed transmission and belt-drive to power the rear wheels. In 1891, the French Panhard et Levassor automobile used a three-speed manual transmission and is considered to have set the template for multi-speed manual transmissions in motor vehicles.
To compensate for the uneven (35/65) weight distribution caused by the rear-mounted engine, DeLorean used rear wheels with a diameter slightly greater than the front wheels. Before that was the rear-engined Škoda's from Škoda 1000MB (produced from 1964) to Škoda 130/135/136 (produced until 1990) or the Polski Fiat 126p (produced until ...
Rowing is the technique of downshifting more than one gear along with the heel-and-toe technique to provide engine braking and smoother deceleration/braking while in the intermediate gears. This provides for maximum braking when going from a top gear to a much lower gear, and optimal engine rpm for exiting the corner. [citation needed]
An automated manual transmission (AMT) is essentially a conventional manual transmission that uses automatic actuation to operate the clutch and/or shift between gears. Many early versions of these transmissions were semi-automatic in operation, such as Autostick , which automatically control only the clutch , but still require the driver's ...
The basic truck is a 6×6 (three axles, six wheels, all of which are powered) heavy truck. Early M939s were rebuilds of M809 vehicle chassis with a new automatic transmission, transfer cases, cab, and hood. Suffix –A2 are new production with later model Cummins engine. The vehicles have a wide variety of configurations and weights. [4] [6] [7]
The final drive then took this output and adjusted it in a fixed-ratio transmission arrangement that was much simpler to build. Final drive ratios of 4:1 were common, [c] meaning that the wheels would turn at one fourth the rate they would if directly connected to the engine.