Ad
related to: effluent pressure for oil cracking engine
Search results
Results From The WOW.Com Content Network
The feedstock to the FCC conversion process usually is heavy gas oil (HGO), which is that portion of the petroleum (crude oil) that has an initial boiling-point temperature of 340 °C (644 °F) or higher, at atmospheric pressure, and that has an average molecular weight that ranges from about 200 to 600 or higher; heavy gas oil also is known as ...
Hydrotreated vegetable oil (HVO) is a biofuel made by the hydrocracking or hydrogenation of vegetable oil. Hydrocracking breaks big molecules into smaller ones using hydrogen while hydrogenation adds hydrogen to molecules. These methods can be used to create substitutes for gasoline, diesel, propane, kerosene and other chemical feedstock.
A delayed coker is a type of coker whose process consists of heating a residual oil feed to its thermal cracking temperature in a furnace with multiple parallel passes. This cracks the heavy, long chain hydrocarbon molecules of the residual oil into coker gas oil and petroleum coke. [1] [2] [3]
There are three types of cokers used in oil refineries: delayed coker, fluid coker and flexicoker. [2] [3] The one that is by far the most commonly used is the delayed coker. The schematic flow diagram below depicts a typical delayed coker: A typical schematic flow diagram of a delayed coking unit
Steam cracking is a petrochemical process in which saturated hydrocarbons are broken down into smaller, often unsaturated, hydrocarbons. It is the principal industrial method for producing the lighter alkenes (or commonly olefins ), including ethene (or ethylene ) and propene (or propylene ).
The rate of cracking and the end products are strongly dependent on the temperature and presence of catalysts. Cracking is the breakdown of large hydrocarbons into smaller, more useful alkanes and alkenes. Simply put, hydrocarbon cracking is the process of breaking long-chain hydrocarbons into short ones. This process requires high temperatures ...
Hydraulic fracturing [a] is a well stimulation technique involving the fracturing of formations in bedrock by a pressurized liquid. The process involves the high-pressure injection of "fracking fluid" (primarily water, containing sand or other proppants suspended with the aid of thickening agents) into a wellbore to create cracks in the deep rock formations through which natural gas, petroleum ...
In naphtha cracking process, C4R2 refers to C4 residual obtained after separation of 1,3-butadiene and isobutylene from C4 raffinate stream and which mainly consists of cis- or trans-2-butene 50~60 wt%, 1-butene 10~15 wt%, and n-butane ~20 wt%. Normally C4R2 is a side product in tert-butyl alcohol plant if C4R1 is used for feed.