Search results
Results From The WOW.Com Content Network
The End-of-Text character (ETX) is a control character used to inform the receiving computer that the end of a record has been reached. This may or may not be an indication that all of the data in a record have been received.
The content of the heading is not defined by the protocol but is defined for each specific device. The heading, if present, is preceded by an SOH (start of heading) character and followed by an STX (start of text). [4] Text data normally follows the heading, begun by the STX, and terminated by ETX (end of text) or ETB (end transmission block).
The start of text character (STX) marked the end of the header, and the start of the textual part of a stream. The end of text character (ETX) marked the end of the data of a message. A widely used convention is to make the two characters preceding ETX a checksum or CRC for error-detection purposes. The end of transmission block character (ETB ...
In teleprinter systems, the sequence "NNNN", on a line by itself, is an end of message indicator. In several Morse code conventions, including amateur radio, the prosign AR (dit dah dit dah dit) means end of message. In the original ASCII code, "EOM" corresponded to code 03 hex, which has since been renamed to "ETX" ("end of text"). [3]
The end-of-text character , also known as control-C, was inappropriate for a variety of reasons, while using control-Z as the control character to end a file is analogous to the letter Z's position at the end of the alphabet, and serves as a very convenient mnemonic aid. A historically common and still prevalent convention uses the ETX ...
Some protocols require each transmission block to end with an end-of-message marker. This is often a control character such as End-of-Text (ETX), End-of-Transmission-Block (ETB), or End-of-Transmission (EOT). Some protocols (especially those requiring ETX) require each transmission block to begin with a Start-of-Text character (STX).
Yes, you should say *something.*
ISO 1745:1975 Information processing – Basic mode control procedures for data communication systems is an early ISO standard defining a Telex-oriented communications protocol that used the non-printable ASCII transmission control characters SOH (Start of Heading), STX (Start of Text), ETX (End of Text), EOT (End of Transmission), ENQ (Enquiry), ACK (Acknowledge), DLE (Data Link Escape), NAK ...