Search results
Results From The WOW.Com Content Network
There are many variations of this type of joint, and the basic mortise and tenon has two components: the mortise hole, and; the tenon tongue. The tenon, formed on the end of a member generally referred to as a rail, fits into a square or rectangular hole cut into the other, corresponding member. The tenon is cut to fit the mortise hole exactly.
A Phoenician joint (Latin: coagmenta punicana) is a locked mortise and tenon wood joinery technique used in shipbuilding to fasten watercraft hulls.The locked (or pegged) mortise and tenon technique consists of cutting a mortise, or socket, into the edges of two planks and fastening them together with a rectangular wooden knob.
Permission is granted to copy, distribute and/or modify this document under the terms of the GNU Free Documentation License, Version 1.2 or any later version published by the Free Software Foundation; with no Invariant Sections, no Front-Cover Texts, and no Back-Cover Texts.
The Wikipedia will use its language if the SVG file supports that language. For example, the German Wikipedia will use German if the SVG file has German. To embed this file in a particular language use the lang parameter with the appropriate language code, e.g. [[File:Mortise tenon joint hull trireme-en.svg|lang=en]] for the
Attribution and Share-Alike required; Any use of this image can be made as long as you credit me (Eric Gaba – Wikimedia Commons user: Sting) as the author and distribute the copies and derivative works under the same license(s) that the one(s) stated below.
The distinguishing feature is that the tenon and the mortise are cut to the full width of the tenon member. The corner bridle joint (also known as a slot mortise and tenon) joins two members at their respective ends, forming a corner. This form of the joint is commonly used to house a rail in uprights, such as legs.
However, due to the precision of fit required for a mortise and tenon joint, this can be a difficult and time-consuming task. Other tools such as a router could be used for the task, but the router usually requires special attachments, jigs or templates and the router bit leaves rounded corners that might need to be squared by hand with a chisel.
The mortise is drilled 1 ⁄ 16 inch (1.6 mm) smaller than the treenail to create a tight fit and take advantage of friction in the mortise. In cases where the treenail is 24 inches (61 cm) or longer, the treenail should be shaped 1 ⁄ 8 inch (3.2 mm) smaller than the other half. In the same case the mortise is drilled in two parts, with a ...