Ads
related to: utp patch cable vs ethernet device switch with port protection connection
Search results
Results From The WOW.Com Content Network
A patch cable, patch cord or patch lead is an electrical or fiber-optic cable used to connect ("patch in") one electronic or optical device to another for signal routing. Devices of different types (e.g., a switch connected to a computer, or a switch to a router ) are connected with patch cords.
An Ethernet crossover cable is a crossover cable for Ethernet used to connect computing devices together directly. It is most often used to connect two devices of the same type, e.g. two computers (via their network interface controllers ) or two switches to each other.
Regardless of copper cable type (Cat 5e/6/6A), the maximum distance is 90 m for the permanent link installation, plus an allowance for a combined 10 m of patch cords at the ends. Cat 5e and Cat 6 can both effectively run power over Ethernet (PoE) applications up to 90 m. However, due to greater power dissipation in Cat 5e cable, performance and ...
Networking cable is a piece of networking hardware used to connect one network device to other network devices or to connect two or more computers to share devices such as printers or scanners. Different types of network cables, such as coaxial cable , optical fiber cable , and twisted pair cables, are used depending on the network's topology ...
A network switch (also called switching hub, bridging hub, Ethernet switch, and, by the IEEE, MAC bridge [1]) is networking hardware that connects devices on a computer network by using packet switching to receive and forward data to the destination device. A network switch is a multiport network bridge that uses MAC addresses to forward data ...
The next packets sent by the network can then be flooded and learned out of the (now enabled) secondary port without any network disruption. Fail-over times are demonstrably in the region of 50ms. The same switch can belong to multiple domains and thus multiple rings. However, these act as independent entities and can be controlled individually.
The terminology generally refers to variants of the Ethernet over twisted pair technology that use a female 8P8C port connection on a computer, or other network device. The X refers to the fact that transmit wires on an MDI device must be connected to receive wires on an MDI-X device.
Most Ethernet cables are wired straight-through (pin 1 to pin 1, pin 2 to pin 2, and so on). In some instances, the crossover form (receive to transmit and transmit to receive) may still be required. A cable for Ethernet may be wired to either the T568A or T568B termination standard at both ends of the cable. Since these standards differ only ...