Ad
related to: transformer fuse cutouts
Search results
Results From The WOW.Com Content Network
In electrical distribution, a fuse cutout or cut-out fuse (often referred to as a cutout) is a combination of a fuse and a switch, used in primary overhead feeder lines and taps to protect distribution transformers from current surges and overloads. An overcurrent caused by a fault in the transformer or customer circuit will cause the fuse to ...
On a 3-phase circuit, a recloser is more beneficial than three separate fuse cutouts. For example, on a wye to delta conversion, when cutouts are used on the wye side and only 1 out of 3 of the cutout fuses open, some customers on the delta side have a low voltage condition, due to voltage transfer through the transformer windings. Low voltage ...
A set of pole-top fusible cutouts with one fuse blown, protecting a transformer - the white tube on the left is hanging down Fuses are used on power systems up to 115,000 volts AC. High-voltage fuses are used to protect instrument transformers used for electricity metering, or for small power transformers where the expense of a circuit breaker ...
The transformer's primary is connected to the distribution line through protective devices called fuse cutouts. In the event of an overload, the fuse melts and the device pivots open to provide a visual indication of the problem.
In electrical engineering, IEC 60269 is a set of technical standards for low-voltage power fuses. [1] The standard is in four volumes, which describe general requirements, fuses for industrial and commercial applications, fuses for residential applications, and fuses to protect semiconductor devices.
Transformer: sometimes changed to "L" for inductor TUN: Tuner: U, IC: Integrated circuit (IC) shorter "U" (unit) is preferred instead of "IC" V: Vacuum tube: VR: Voltage regulator (voltage reference), or variable resistor (potentiometer / trimmer / rheostat) voltage regulators are often "U" for IC, pots and trimmers often "R" for resistor X
Electric transformers (2 C, 68 P) Electrical generators (6 C, 72 P) F. Fuses (5 P) I. Inverters (1 C, 8 P) L. Liquid dielectrics (1 C, 9 P) O. ... Fuse (electrical ...
A fuse contains a short piece of wire which melts if too much current flows. This effectively disconnects the power supply from its load, and the equipment stops working until the problem that caused the overload is identified and the fuse is replaced. Some power supplies use a very thin wire link soldered in place as a fuse. Fuses in power ...