When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Resaw - Wikipedia

   en.wikipedia.org/wiki/Resaw

   A resaw is a large band saw optimized for cutting timber along the grain to reduce larger sections into smaller sections or veneers. Resawing veneers requires a wide blade – commonly 2 to 3 inches (52–78 mm) – with a small kerf to minimize waste. Resaw blades of up to 1 inch (26 mm) may be fitted to a standard band saw.

3. Bandsaw - Wikipedia

   en.wikipedia.org/wiki/Bandsaw

   A bandsaw (also written band saw) is a power saw with a long, sharp blade consisting of a continuous band of toothed metal stretched between two or more wheels to cut material. They are used principally in woodworking , metalworking , and lumbering , but may cut a variety of materials.

4. Ring saw - Wikipedia

   en.wikipedia.org/wiki/Ring_saw

   The oblong bandsaw has a blade that is supported on two large wheels. [5] [note 2] The interval between the two wheels is supported by blade guides immediately behind the cutting zone. [5] Ring saws do not have the same straight run of blade, nor the opportunity to support much of the blade as with the wheels of a bandsaw.

5. Saw - Wikipedia

   en.wikipedia.org/wiki/Saw

   The basic version has a circular blade fixed at a 90° angle to the vertical. A "compound miter saw" has a blade that can be adjusted to other angles. A "sliding compound miter saw" has a blade that can be pulled through the work, in an action similar to that of a radial-arm saw, which provides more capacity for cutting wider workpieces.

6. Splitting band knife - Wikipedia

   en.wikipedia.org/wiki/Splitting_band_knife

   The DBDE execution blade can have a parallel or twisted 180 degrees welding. The twisted welding execution saves a grinding unit, as both edges pass the same grinding unit after two turns. It has been observed that a narrow width on a vertical band knife machine gives better dimensional accuracies on the foam block. The wider the vertical ...

7. Rip cut - Wikipedia

   en.wikipedia.org/wiki/Rip_cut

   Rip cuts are commonly made with a table saw, but other types of power saws can also be used, including a radial arm saw, band saw, and hand held circular saw.In sawmills the head saw is the first rip-saw a log goes through, which is sometimes a gang-saw, and then the cants may be resawn using other saws and then edged in an edger and sometimes cut to length by a crosscut saw.