Search results
Results From The WOW.Com Content Network
The upper curve is the line of liquidus, and the lower curve is the line of solidus. In chemistry, materials science, and physics, the liquidus temperature specifies the temperature above which a material is completely liquid, [2] and the maximum temperature at which crystals can co-exist with the melt in thermodynamic equilibrium.
A phase diagram in physical ... The liquidus is the temperature above which the ... A typical phase diagram. The solid green line shows the behaviour of the ...
In chemistry, the lever rule is a formula used to determine the mole fraction (x i) or the mass fraction (w i) of each phase of a binary equilibrium phase diagram.It can be used to determine the fraction of liquid and solid phases for a given binary composition and temperature that is between the liquidus and solidus line.
A phase diagram for a fictitious binary chemical mixture (with the two components denoted by A and B) used to depict the eutectic composition, temperature, and point. ( L denotes the liquid state.) A eutectic system or eutectic mixture ( / j uː ˈ t ɛ k t ɪ k / yoo- TEK -tik ) [ 1 ] is a type of a homogeneous mixture that has a melting point ...
In areas on a phase diagram which are not covered by a solid solution there may be line phases, these are compounds with a known crystal structure and set stoichiometry. Where the crystalline phase consists of two (non-charged) organic molecules the line phase is commonly known as a cocrystal.
A typical phase diagram.The solid green line applies to most substances; the dashed green line gives the anomalous behavior of water. In thermodynamics, the triple point of a substance is the temperature and pressure at which the three phases (gas, liquid, and solid) of that substance coexist in thermodynamic equilibrium. [1]
A typical phase diagram for a single-component material, exhibiting solid, liquid and gaseous phases. The solid green line shows the usual shape of the liquid–solid phase line. The dotted green line shows the anomalous behavior of water when the pressure increases. The triple point and the critical point are shown as red dots.
When the phase change occurs, there is a "thermal arrest"; that is, the temperature stays constant. This is because the matter has more internal energy as a liquid or gas than in the state that it is cooling to. The amount of energy required for a phase change is known as latent heat. The "cooling rate" is the slope of the cooling curve at any ...