Ads
related to: garboard drain plugs for boats
Search results
Results From The WOW.Com Content Network
Garboard strakes and related near-keel members Diagram of typical modern metal-hulled ship’s exterior plating, with a single strake highlighted in red. On a vessel's hull, a strake is a longitudinal course of planking or plating which runs from the boat's stempost (at the bows) to the sternpost or transom (at the rear).
A drain plug hole about 25 mm (1 inch) was drilled in the garboard plank on one side to allow rain water drainage. The oars did not use rowlocks or thole pins but holes cut below the gunwale line. To keep seawater out, these oar holes were sealed with wooden disks from the inside, when the oars were not in use.
A limber hole is a drain hole through a frame or other structural member of a boat designed to prevent water from accumulating against one side of the frame, and allowing it to drain toward the bilge. Limber holes are common in the bilges of wooden boats. The term may be extended to cover drain holes in floors.
A scupper is an opening in the side walls of a vessel or an open-air structure, which allows water to drain instead of pooling within the bulwark or gunwales of a vessel, or within the curbing or walls of a building. Ship's bulwark. 1. Gunwale, 2. Bulwark plating, 3. Flange, 4. Stanchion, 5. Stringer plate, 6. Stringer angle, 7. Sheerstrake.
An autoCAD drawing of the various plating strakes on a convention hull.. A strake is the name given to each line of planking in a wooden vessel. [1] In modern ship construction it refers to the longitudinal run of plating covering the hull, deck and bulkhead structure.
Boat building is the design and construction of boats (instead of the larger ships) — and their on-board systems. This includes at minimum the construction of a hull , with any necessary propulsion, mechanical, navigation, safety and other service systems as the craft requires.
Ad
related to: garboard drain plugs for boats