Ads
related to: air compressor end piece for water treatment
Search results
Results From The WOW.Com Content Network
(The compressor is on the surface and no mechanical parts are needed in the well). However airlift wells must be much deeper than the water table to allow for submergence. Air is generally pumped at least as deep under the water as the water is to be lifted. (If the water table is 50 ft below, the air should be pumped 100 feet deep).
The compressed air rises to the top of the separation chamber (wind box). The separation chamber has a compressed-air takeoff pipe, and the compressed air can be used as a power source. The energy of the falling water creates a partial vacuum inside the pipe that is compensated by the air from the outside atmosphere provided through inlet.
Atlas Copco companies develop, manufacture, service, and rent industrial tools, air compressors (of which it is the world's leading producer), [8] construction and assembly systems. The Group operates in four areas: Compressor Technology, Vacuum Technology, Power Technology and Industrial Technology.
After compressed air cools, then the vaporized water turns to liquefied water. [15] [16] Cooling the air as it leaves the compressor will take most of the moisture out before it gets into the piping. Aftercooler, storage tanks, etc. can help the compressed air cool to 104 °F; two-thirds of the water then turns to liquid. [17]
Fitting profiles have identifiable geometry on the male end, but care must be taken to use a compatible coupler. Couplers use springs and balls to lock mating nipples into place. A seal is effected using O-rings along the shaft of the nipple or by compression by the tip.
In the case of small reciprocating compressors, the compressor flywheel may drive a cooling fan that directs ambient air across the intercooler of a two or more stage compressor. Because rotary screw compressors can make use of cooling lubricant to reduce the temperature rise from compression, they very often exceed a 9 to 1 compression ratio.