Search results
Results From The WOW.Com Content Network
Atmospheric pollutant concentrations expressed as mass per unit volume of atmospheric air (e.g., mg/m 3, μg/m 3, etc.) at sea level will decrease with increasing altitude because the atmospheric pressure decreases with increasing altitude.
The grain per gallon (gpg) is a unit of water hardness defined as 1 grain (64.8 milligrams) of calcium carbonate dissolved in 1 US gallon of water (3.785412 L). It translates into 1 part in about 58,000 parts of water or 17.1 parts per million (ppm). Also called Clark degree (in terms of an imperial gallon).
At 10 000 ppm the solution is a deep red colour. As the concentration decreases the colour becomes orange, then a vibrant yellow, with the final 1 ppm sample a very pale yellow. In science and engineering , the parts-per notation is a set of pseudo-units to describe small values of miscellaneous dimensionless quantities , e.g. mole fraction or ...
Parts per million (ppm) is usually defined as 1 mg/L CaCO 3 (the definition used below). [20] It is equivalent to mg/L without chemical compound specified, and to American degree . Grain per gallon (gpg) is defined as 1 grain (64.8 mg) of calcium carbonate per U.S. gallon (3.79 litres), or 17.118 ppm.
mg/m 3 = milligrams of pollutant per cubic meter of air at sea level atmospheric pressure and T: ppmv = air pollutant concentration, in parts per million by volume T = ambient temperature in K = 273. + °C 0.082057338 = Universal gas constant in L atm mol −1 K −1: M = molecular mass (or molecular weight) of the air pollutant
where TDS is expressed in mg/L and EC is the electrical conductivity in microsiemens per centimeter at 25 °C. The conversion factor k e varies between 0.55 and 0.8. [5] Some TDS meters use an electrical conductivity measurement to the ppm using the above formula. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 g of water. [6]
Its units are in parts per million (ppm) for gases and in milligrams per cubic meter (mg/m 3) for particulates such as dust, smoke and mist. The basic formula for converting between ppm and mg/m 3 for gases is ppm = (mg/m^3) * 24.45 / molecular weight. This formula is not applicable to airborne particles.
In water testing hardness is often measured in parts per million (ppm), where one part per million is defined as one milligram of calcium carbonate (CaCO 3) per litre of water. Consequently, 1 dGH corresponds to 10 ppm CaO but 17.848 ppm CaCO 3 which has a molar mass of 100.09 g/mol.