Ads
related to: sata connector power supply
Search results
Results From The WOW.Com Content Network
Serial ATA power connectors: a 15-pin connector for components that use SATA power plugs. This connector supplies power at three different voltages: +3.3, +5, and +12 V, in three pins per wire, one designed to precharge capacitive loads on for hot-plugging designed backplanes.
A 3.5-inch Serial ATA hard disk drive A 2.5-inch Serial ATA solid-state drive. SATA was announced in 2000 [4] [5] in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing ...
The SAS is a new generation serial communication protocol for devices designed to allow for much higher speed data transfers and is compatible with SATA. SAS uses a mechanically identical data and power connector to standard 3.5-inch SATA1/SATA2 HDDs, and many server-oriented SAS RAID controllers are also capable of addressing SATA hard drives.
eSATAp combines the functionality of an eSATA and a USB port, and a source of power in a single connector. eSATAp can supply power at 5 V and 12 V. On a desktop computer the port is simply a connector, usually mounted on a bracket at the back accessible from outside the machine, connected to motherboard sources of SATA, USB, and power at 5 V ...
As SATA becomes more prevalent, Molex connectors can be found repurposed, through use of an adaptor, to serve as six-pin PCIe power connectors to make up for a lack of such connectors on a power supply. Lower power devices (e.g. 3.5-inch floppy drives) use the smaller AMP 171822-4 connector instead.
U.3 (SFF-TA-1001) is built on the U.2 spec and uses the same SFF-8639 connector. A single "tri-mode" (PCIe/SATA/SAS) backplane receptacle can handle all three types of connections; the controller automatically detects the type of connection used. This is unlike U.2, where users need to use separate controllers for SATA/SAS and NVMe.