Ads
related to: filling cracks in concrete floor in basement drain
Search results
Results From The WOW.Com Content Network
The drainage system collects any water entering the basement and drains it to an internally placed sump pump system, which will then pump the water out of the basement. The Federal Emergency Management Agency (FEMA) recommends basement waterproofing with a water alarm and "battery-operated backup pump" as a preventive measure against the high ...
The filling of cracks, fissures or voids in concrete for structural purposes (restoration of strength and load-bearing capability), or non-structural reasons (flexible repairs where further movement is expected, or alternately to resist water and gas permeation) typically involves the injection of low viscosity resins or grouts based on epoxy ...
Integral damp proofing in concrete involves adding materials to the concrete mix to make the concrete itself impermeable. [ 4 ] Surface suppressant coating with thin water proof materials such as epoxy resin for resistance to non-pressurized moisture such as rain water or a coating of cement sprayed on such as shotcrete which can resist water ...
Masonry walls are built with a damp-proof course to prevent rising damp, and the concrete in foundations needs to be damp-proofed or waterproofed with a liquid coating, basement waterproofing membrane (even under the concrete slab floor where polyethylene sheeting is commonly used), or an additive to the concrete.
Rising damp from the ground may be prevented by most simple means. Six inches of good Portland cement concrete should cover the whole site of the dwelling, and concrete never less than nine inches thick should underlie all walls. A damp course should disconnect the whole of the foundations from the superstructure.
When a reinforced concrete member is put in tension, after cracking, the member elongates by widening of cracks and by formation of new cracks. Figure 1 Formation of internal cracks. Ignoring the small elastic strain in the concrete between the cracks, we can relate the crack width to the strain of the member by:
Ad
related to: filling cracks in concrete floor in basement drain