Search results
Results From The WOW.Com Content Network
Ping measures the round-trip time for messages sent from the originating host to a destination computer that are echoed back to the source. The name comes from active sonar terminology that sends a pulse of sound and listens for the echo to detect objects under water. [1] Ping operates by means of Internet Control Message Protocol (ICMP) packets.
The user's computer has an IP address stuffed manually into its address table (normally with the arp command with the MAC address taken from a label on the device) The computer sends special packets to the device, typically a ping packet with a non-default size. The device then adopts this IP address
Requests the direct IP address of the user with the specified nickname. This command is often used to obtain the IP of an abusive user to more effectively perform a ban. It is unclear what, if any, privileges are required to execute this command on a server. This command is not formally defined by an RFC, but is in use by some IRC daemons.
arping is a software utility for discovering hosts on a computer network by sending link layer frames using Address Resolution Protocol (ARP) requests addressed to a host identified by its MAC address. [1] The utility may use ARP to resolve an IP address provided by the user.
Paping (pronounced pah ping) is a computer network administration utility used to test the reachability of a host on an Internet Protocol (TCP/IP) network and to measure the time it takes to connect to a specified port. The name is a play on the word ping, another computer network administration utility.
Then, the command ipconfig /renew is executed to request a new IP address. [3] [4] Where a computer is connected to a cable or DSL modem, it may have to be plugged directly into the modem network port to bypass the router, before using ipconfig /release and turning off the power for a period of time, to ensure that the old IP address is taken ...
A well-known example of this is the ping utility. [7] ICMP responses will be allowed back through the firewall. In some scenarios, UDP communication can use ICMP to provide information about the state of the session so ICMP responses related to a UDP session will also be allowed back through.
In computing, traceroute and tracert are diagnostic command-line interface commands for displaying possible routes (paths) and transit delays of packets across an Internet Protocol (IP) network. The command reports the round-trip times of the packets received from each successive host (remote node) along the route to a destination.