Search results
Results From The WOW.Com Content Network
Electric eye for a garage door opener. An electric eye is a photodetector used for detecting obstruction of a light beam. An example is the door safety system used on garage door openers that use a light transmitter and receiver at the bottom of the door to prevent closing if there is any obstruction in the way that breaks the light beam.
opener 81a 1 out 81b 2 out 82 lock in 82a 1st out 82b 2nd out 82z 1st in 82y 2nd in 83 multi position switch, in 83a out position 1 83b out position 2 Relay; 85 relay coil - Important if relay coil has flyback diode in parallel 86 relay coil + Important if relay coil has diode in parallel Relay contacts 87 common contact 30/51 87a
The system typically features three buttons, most often found on the driver-side visor or on the overhead console, which can be programmed via a training sequence to replace existing remote controls. It is compatible with most RF-controlled garage door openers, as well as home automation systems such as those based on the X10 protocol.
The electric overhead garage door opener was invented by C.G. Johnson in 1926 in Hartford City, Indiana. [1] Electric Garage Door openers did not become popular until Era Meter Company of Chicago offered one after World War II where the overhead garage door could be opened via a key pad located on a post at the end of the driveway or a switch inside the garage.
Electric gates are recommended to be used in combination with other security features to install a full security system. A few of these features are closed circuits with security cameras , additional gates in conjunction with the main gate, electronic keycards and keypads, security guards .
A typical single-car garage roller door has a preloaded spring inside the rolling mechanism. The spring reduces the effort required to open the door. Oversized roller doors in commercial premises are not sprung (except in the US), and a manual pulley and chain system or a geared motor is used to raise and lower (roll up and roll down) the door.
Pressing a button on the key unlocks all of the car doors. Another button locks the car. In 1980, Ford Motor Company introduced an external keypad-type keyless entry system, wherein the driver entered a numeric combination —either pre-programmed at the factory or one programmed by the owner— to unlock the car without the key.
A rolling code (or sometimes called a hopping code) is used in keyless entry systems to prevent a simple form of replay attack, where an eavesdropper records the transmission and replays it at a later time to cause the receiver to 'unlock'. Such systems are typical in garage door openers and keyless car entry systems.