Search results
Results From The WOW.Com Content Network
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...
The rhombic antenna is a directional wire antenna used on MF and HF bands for shortwave reception. The antenna consists of a wire suspended above the ground in the shape of a rhombus , terminated at one end by a resistor equal the the wire's characteristic impedance, about 400 to 600 ohms, and at the other end connected to the feedline to the ...
English: The image gives six circuit diagrams (schematics) for balanced line antenna tuners of the tuned-transformer type, discussed in the Wikipedia article "Antenna Tuner" or "ATU". It is an edited version of the original by JNRSTANLEY uploaded 2014-10-15.
A rhombic antenna is made of four sections of wire suspended parallel to the ground in a diamond or "rhombus" shape. Each of the four sides is the same length – about a quarter-wavelength to one wavelength per section – converging but not touching at an angle of about 42° at the fed end and at the far end.
English: Diagram of an umbrella antenna, a toploaded wire transmitting antenna used in the medium frequency (MF), low frequency (LF) and very low frequency (VLF) bands. It consists of a steel mast (grey) insulated from the ground, with diagonal wires radiating from the top, anchored to the ground in a circle around it. The feedline from the ...
The ground rods create a ground plane under the antenna which increases the gain. The ground rods may extend horizontally from the base, but in antennas fed by coaxial cable as shown here they are usually sloped downward to increase the radiation resistance of the antenna from the 36 ohms of a quarter wave monopole closer to 50 ohms, so the ...
An automotive wiring diagram, showing useful information such as crimp connection locations and wire colors. These details may not be so easily found on a more schematic drawing. A wiring diagram is a simplified conventional pictorial representation of an electrical circuit. It shows the components of the circuit as simplified shapes, and the ...
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...