Ads
related to: delta secondary fasteners
Search results
Results From The WOW.Com Content Network
The EELV Secondary Payload Adapter (ESPA) is an adapter for launching secondary payloads on orbital launch vehicles.. Originally developed for US launch vehicles in the 2000s to launch secondary payloads on space missions of the United States Department of Defense that used the Atlas V and Delta IV, the adapter design has become a de facto standard and is now also used for spaceflight missions ...
The delta v required to reach low Earth orbit (or the required velocity of a sufficiently heavy suborbital payload) requires a wet to dry mass ratio larger than has been achieved in a single rocket stage. The multistage rocket overcomes this limit by splitting the delta-v into fractions.
High-leg delta service is supplied in one of two ways. One is by a three-phase transformer (or three single-phase transformers), having four wires coming out of the secondary, the three phases, plus a neutral connected as a center-tap on one of the windings. Another method (the open delta configuration) requires two transformers.
An example would be a distribution transformer with a delta primary, running on three 11 kV phases with no neutral or earth required, and a star (or wye) secondary providing a 3-phase supply at 415 V, with the domestic voltage of 240 available between each phase and the earthed (grounded) neutral point.
In 1945, Rockwell Manufacturing Company acquired Delta Machinery and renamed it the Delta Power Tool Division of Rockwell Manufacturing Company and continued to manufacture in Milwaukee. In 1966, Rockwell invented the world's first power miter saw. In 1981, Rockwell's power tool group was acquired by Pentair and re-branded Delta Machinery.
For example, a transformer with a vector group of Dy1 has a delta-connected HV winding and a wye-connected LV winding. The phase angle of the LV winding lags the HV by 30 degrees. Note that the high-voltage (HV) side always comes before the low-voltage (LV) side, regardless of which is the primary winding.
A safety wire is used to ensure proper security for a fastener. The wire needed is long enough to reach from a fixed location to a hole in the removable fastener, such as a pin — a clevis fastener, sometimes a linchpin or hitch-pin through a clevis yoke for instance — and the wire pulled back upon itself, parallel to its other end, then twisted, a single end inserted through a fastener ...
Secondary sealing elements included O-rings, wedges, U-cups and various packings. Carbon-graphite was widely used as a seal face material; the mating seal face was often cast iron, Ni-resist, 400 series stainless steel, Stellite or aluminum oxide although tungsten carbide was coming into use.