Search results
Results From The WOW.Com Content Network
A fixed-point representation of a fractional number is essentially an integer that is to be implicitly multiplied by a fixed scaling factor. For example, the value 1.23 can be stored in a variable as the integer value 1230 with implicit scaling factor of 1/1000 (meaning that the last 3 decimal digits are implicitly assumed to be a decimal fraction), and the value 1 230 000 can be represented ...
The Q notation, as defined by Texas Instruments, [1] consists of the letter Q followed by a pair of numbers m. n, where m is the number of bits used for the integer part of the value, and n is the number of fraction bits. By default, the notation describes signed binary fixed point format, with the unscaled integer being stored in two's ...
To divide a fraction by a whole number, you may either divide the numerator by the number, if it goes evenly into the numerator, or multiply the denominator by the number. For example, 10 3 ÷ 5 {\displaystyle {\tfrac {10}{3}}\div 5} equals 2 3 {\displaystyle {\tfrac {2}{3}}} and also equals 10 3 ⋅ 5 = 10 15 {\displaystyle {\tfrac {10}{3\cdot ...
If the divisor has a fractional part, one can restate the problem by moving the decimal to the right in both numbers until the divisor has no fraction, which can make the problem easier to solve (e.g., 10/2.5 = 100/25 = 4). Division can be calculated with an abacus. [14]
For example, multiplying the lengths (in meters or feet) of the two sides of a rectangle gives its area (in square meters or square feet). Such a product is the subject of dimensional analysis. The inverse operation of multiplication is division. For example, since 4 multiplied by 3 equals 12, 12 divided by 3 equals 4.
In other words, for the quantities a and b, it can be said that b is a multiple of a if b = na for some integer n, which is called the multiplier. If a is not zero, this is equivalent to saying that / is an integer. When a and b are both integers, and b is a multiple of a, then a is called a divisor of b. One says also that a divides b.
Long division is the standard algorithm used for pen-and-paper division of multi-digit numbers expressed in decimal notation. It shifts gradually from the left to the right end of the dividend, subtracting the largest possible multiple of the divisor (at the digit level) at each stage; the multiples then become the digits of the quotient, and the final difference is then the remainder.
The percent value can also be found by multiplying first instead of later, so in this example, the 50 would be multiplied by 100 to give 5,000, and this result would be divided by 1,250 to give 4%. To calculate a percentage of a percentage, convert both percentages to fractions of 100, or to decimals, and multiply them. For example, 50% of 40% is: