Search results
Results From The WOW.Com Content Network
Two additional displacements were produced during the engine's history. A 351 cu in (5.8 L) model was offered beginning in 1969 and continuing until 1996. The 351W (so identified to distinguish from the 335-series Cleveland-produced 351C) uses a taller block than the other engines in the series to avoid excessively short connecting rods. And ...
The Q-code 351 "Cobra-Jet" (also called 351-CJ, 351-4V) was produced from May 1971 through the 1974 model year. It was a lower-compression design that used open-chamber 4V heads. [ 5 ] The open-chamber heads exhibited superior emissions characteristics and were used to meet the more stringent emissions standards for 1972 and beyond. [ 1 ]
This means that the generally inferior flow of a reverse-flow head is less of a disadvantage. In the early days of turbo charging a reverse-flow head allowed the compressor outlet of a turbocharger to blow directly into the inlet manifold with either a blow-through or draw-through carburettor and no intercooler. This allowed the use of shorter ...
351 Cleveland V8 (not the 351 Cleveland M-block engine) 351 Boss; 351 Cobra Jet; 302 Windsor V8; 351 Windsor V8; 400 Cleveland Ford 335 engine#400 V8 aka 400FMX certain 1973 casting numbers D1AE and D3AE, mated to the FMX transmission) 3.8/3.9/4.2L Canadian Essex 90° V6 (RWD only) 240 I6; 300 4.9 I6; 4.6L Modular V8 (first two casting runs ...
Ford — Dual-Stage Intake (DSI), on their Duratec 2.5 and 3.0-litre V6s, and it was also found on the Yamaha V6 in the Taurus SHO. The Ford Modular V8 engines and the V6 Cologne use either the Intake Manifold Runner Control ( IMRC ) for four-valve engines, or the Charge Motion Control Valve ( CMCV ) for three-valve engines.
Four-stroke cycle used in gasoline/petrol engines: intake (1), compression (2), power (3), and exhaust (4). The right blue side is the intake port and the left brown side is the exhaust port. The cylinder wall is a thin sleeve surrounding the piston head which creates a space for the combustion of fuel and the genesis of mechanical energy.
Diagram of a typical gas turbine jet engine. Air is compressed by the compressor blades as it enters the engine, and it is mixed and burned with fuel in the combustion section. The hot exhaust gases provide forward thrust and turn the turbines which drive the compressor blades. 1. Intake 2. Low pressure compression 3. High pressure compression ...
The Chrysler B and RB engines are a series of big-block V8 gasoline engines introduced in 1958 to replace the Chrysler FirePower (first generation Hemi) engines. The B and RB engines are often referred to as "wedge" engines because they use wedge-shaped combustion chambers; this differentiates them from Chrysler's 426 Hemi big block engines that are typically referred to as "Hemi" or "426 Hemi ...