Ads
related to: small ball hitch and coupler
Search results
Results From The WOW.Com Content Network
The trailer tongue (North America) or coupling (outside North America) slips over a trailer hitch ball attached to a receiver hitch mount or integral with the hitch. A larger, heavy-duty gooseneck ball size: 3 in (76.2 mm) is typically used for towing greater than 10,000 pounds (4.5 t), and this towing capacity falls outside of the scope of SAE ...
The Aero Coupler patent drawing (1928) For the Aerocar Curtiss invented a new type of shock-absorbing fifth wheel hitch called the Aero Coupler (sometimes "Aerocoupler"). [5] A similar hitch was used in The Brighton Trailer and may have been the hitch referred to (but not patented) in the Curtiss Camp Car patent of 1921.
Adjustable three-point ball on lift arm. Ball may be rotated to fit either Category I or Category II implements Rear three-point hitch of a Case IH tractor with implement attached by the drawbar. There are five different hitch sizes, called categories. The higher category hitches have sturdier lift arms and larger connector pins. [2]
This design uses a tiny stainless steel ball to lock the knuckle closed. Uncoupling is achieved by holding a magnetic wand over the coupler pair to draw the balls out of the locking pockets. In O scale, an exact-scale working miniature version of the "Alliance" coupler was manufactured from the 1980s by GAGO models in Australia.
The diagram from Beard's 1897 coupler patent [1]. Janney couplers were first patented in 1873 by Eli H. Janney (U.S. patent 138,405). [2] [3] Andrew Jackson Beard was amongst various inventors that made a multitude of improvements to the knuckle coupler; [1] Beard's patents were U.S. patent 594,059 granted 23 November 1897, which then sold for approximately $50,000, and U.S. patent 624,901 ...
Ball and Socket Coupler. Most trailers are towed by joining a ball and a coupler (socket). [1] The coupler is attached to the trailer, and the ball hitch is attached to the tow vehicle. The coupler slides over the ball hitch. Then, pressure is applied to a clamp, usually with a toggle or lever, which secures the ball in the coupler.