Ad
related to: fuse blowing problems
Search results
Results From The WOW.Com Content Network
A time-delay fuse (also known as an anti-surge or slow-blow fuse) is designed to allow a current which is above the rated value of the fuse to flow for a short period of time without the fuse blowing. These types of fuse are used on equipment such as motors, which can draw larger than normal currents for up to several seconds while coming up to ...
A common and simple version of this problem asks to measure a time of 45 seconds using only two fuses that each burn for a minute. The assumptions of the problem are usually specified in a way that prevents measuring out 3/4 of the length of one fuse and burning it end-to-end, for instance by stating that the fuses burn unevenly along their length.
An open-circuit fault occurs if a circuit is interrupted by a failure of a current-carrying wire (phase or neutral) or a blown fuse or circuit breaker. In three-phase systems, a fault may involve one or more phases and ground, or may occur only between phases. In a "ground fault" or "earth fault", current flows into the earth.
In electrical distribution, a fuse cutout or cut-out fuse (often referred to as a cutout) is a combination of a fuse and a switch, used in primary overhead feeder lines and taps to protect distribution transformers from current surges and overloads. An overcurrent caused by a fault in the transformer or customer circuit will cause the fuse to ...
Loose or poor connections in traditional electrical accessories and switchgear can cause heat to develop capable of starting a fire. This problem is known as High Resistance Connection (HRC) and safety devices such as fuses and Residual Current Devices (RCDs) are unable to disconnect the electrical supply because they cannot detect a HRC.
The origin of the term is to bridge or "short" the fuses of an electrical apparatus before entering combat, so that the fuse blowing will not stop the equipment from operating. According to Allied Ordnance Publication AOP-38-3, [ 1 ] a NATO publication, a battleshort is "The capability to bypass certain safety features in a system to ensure ...
This should have made Mullis happy, but there was a problem. While Mullis was still working on his initial paper describing PCR, his colleagues were prolifically publishing the results of their ...
An inrush current limiter is a component used to limit inrush current to avoid gradual damage to components and avoid blowing fuses or tripping circuit breakers.Negative temperature coefficient (NTC) thermistors and fixed resistors are often used to limit inrush current.