When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. dBm - Wikipedia

   en.wikipedia.org/wiki/DBm

   A schematic showing the relationship between dBu (the voltage source) and dBm (the power dissipated as heat by the 600 Ω resistor). dBm or dB mW (decibel-milliwatts) is a unit of power level expressed using a logarithmic decibel (dB) scale respective to one milliwatt (mW).

3. Decibel - Wikipedia

   en.wikipedia.org/wiki/Decibel

   A power level of 0 dBm corresponds to one milliwatt, and 1 dBm is one decibel greater (about 1.259 mW). In professional audio specifications, a popular unit is the dBu . This is relative to the root mean square voltage which delivers 1 mW (0 dBm) into a 600-ohm resistor, or √ 1 mW × 600 Ω ≈ 0.775 V RMS .

4. List of thermal conductivities - Wikipedia

   en.wikipedia.org/wiki/List_of_thermal_conductivities

   Mixtures may have variable thermal conductivities due to composition. Note that for gases in usual conditions, heat transfer by advection (caused by convection or turbulence for instance) is the dominant mechanism compared to conduction. This table shows thermal conductivity in SI units of watts per metre-kelvin (W·m −1 ·K −1).

5. Decibel watt - Wikipedia

   en.wikipedia.org/wiki/Decibel_watt

   The decibel watt (dBW or dB W) is a unit for the measurement of the strength of a signal expressed in decibels relative to one watt.It is used because of its capability to express both very large and very small values of power in a short range of number; e.g., 1 milliwatt = −30 dBW, 1 watt = 0 dBW, 10 watts = 10 dBW, 100 watts = 20 dBW, and 1,000,000 W = 60 dBW.

6. Orders of magnitude (power) - Wikipedia

   en.wikipedia.org/wiki/Orders_of_magnitude_(power)

   For reference, about 10,000 100-watt lightbulbs or 5,000 computer systems would be needed to draw 1 MW. Also, 1 MW is approximately 1360 horsepower . Modern high-power diesel-electric locomotives typically have a peak power of 3–5 MW, while a typical modern nuclear power plant produces on the order of 500–2000 MW peak output.

7. True RMS converter - Wikipedia

   en.wikipedia.org/wiki/True_RMS_converter

   For example, if 120 V AC RMS is applied to a resistive heating element it would heat up by exactly the same amount as if 120 V DC were applied. This principle was exploited in early thermal converters. The AC signal would be applied to a small heating element that was matched with a thermistor, which could be used in a DC measuring circuit.

8. Thermal conductivity and resistivity - Wikipedia

   en.wikipedia.org/wiki/Thermal_conductivity_and...

   The thermal conductivity of a material is a measure of its ability to conduct heat.It is commonly denoted by , , or and is measured in W·m −1 ·K −1.. Heat transfer occurs at a lower rate in materials of low thermal conductivity than in materials of high thermal conductivity.

9. Thermal conductance and resistance - Wikipedia

   en.wikipedia.org/wiki/Thermal_conductance_and...

   It is measured in units of kelvins per watt (K/W) and indicates how much temperature difference (in kelvins) is required to transfer a unit of heat current (in watts) through the material or object. It is essential to optimize the building insulation , evaluate the efficiency of electronic devices, and enhance the performance of heat sinks in ...