Ads
related to: chuck clamping kit
Search results
Results From The WOW.Com Content Network
A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.
Several machine collets (top and centre) and a dismantled pin chuck (below). Generally, a collet chuck, [3] considered as a unit, consists of a tapered receiving sleeve (sometimes integral with the machine spindle), the collet proper (usually made of spring steel) which is inserted into the receiving sleeve, and (often) a cap that screws over the collet, clamping it via another taper.
The large male taper takes a lathe chuck, which is retained by the large nut. A machine taper is a system for securing cutting tools or toolholders in the spindle of a machine tool or power tool. A male member of conical form (that is, with a taper) fits into the female socket, which has a matching taper of equal angle.
The drawbar pull is an important component that allows the milling machine to keep the tool in place while it’s being used. The force from the drawbar pull supplied to the tool has to be just right because not enough force would cause the tool to wobble leading to inaccuracy, and too much force would apply excessive stress, leading to shorter tool life.
The arbor or chuck on a magnetic drill is attached to the motor. It is a type of clamp used to attach the core drills. There are mainly two types of chuck available for the magnetic drill, industrial arbor (manual tightening) and quick change drill chucks. The quick change drill chucks are easy and fast option to attach the core drills.
In machine tools, a spindle is a rotating axis of the machine, which often has a shaft at its heart. The shaft itself is called a spindle, but also, in shop-floor practice, the word often is used metonymically to refer to the entire rotary unit, including not only the shaft itself, but its bearings and anything attached to it (chuck, etc.).