Ad
related to: acre to square mile converter
Search results
Results From The WOW.Com Content Network
One acre equals 1 ⁄ 640 (0.0015625) square mile, 4,840 square yards, 43,560 square feet, [2] or about 4,047 square metres (0.4047 hectares) (see below).While all modern variants of the acre contain 4,840 square yards, there are alternative definitions of a yard, so the exact size of an acre depends upon the particular yard on which it is based.
History. The size of the mile and acre are derived from the length of the surveyor's rod, a unit which in Ireland was called a perch (or linear perch to distinguish it from the square perch). A mile is 320 linear perches and an acre is 160 square perches. The length of the perch was not standardised nationwide at the time of the Tudor conquest ...
Square miles should not be confused with miles square, a square region with each side having a length of the value given. For example, a region which is 20 miles square (20 mi × 20 mi) has an area of 400 sq mi; a rectangle of measuring 10 mi × 40 mi also has an area of 400 sq mi, but is not 20 miles square.
The rod is useful as a unit of length because integer multiples of it can form one acre of square measure (area). The 'perfect acre' [2] is a rectangular area of 43,560 square feet, bounded by sides 660 feet (a furlong) long and 66 feet (a chain) wide (220 yards by 22 yards) or, equivalently, 40 rods by 4 rods. An acre is therefore 160 square ...
Table of length units. The Maltese inch. Exactly 55⁄64 imperial inches. This unit is not in the 1921 act. The Maltese hand span, equivalent to the foot. Exactly 10 + 5⁄16 imperial inches. This is exactly 82 + 1⁄2 inches, or 6 ft 10 + 1⁄2 in. It corresponds to the fathom, but was used in both land and sea contexts.
statvolt (CGS unit) statV. ≘ c ⋅ (1 μJ/A⋅m) = 299.792458V. volt (SI unit) V. The difference in electric potential across two points along a conducting wire carrying one ampere of constant current when the power dissipated between the points equals one watt. [ 32 ] = 1 V = 1 W/A = 1 kg⋅m2/ (A⋅s3) = 1 J/C.
Since an acre measured 10 square chains in Gunter's system, the entire process of land area measurement could be computed using measurements in chains, and then converted to acres by dividing the results by 10. [2] Hence 10 chains by 10 chains (100 square chains) equals 10 acres, 5 chains by 5 chains (25 square chains) equals 2.5 acres.
An input unit can be converted to any number of output units—the outputs are specified as a "combination" by separating unit codes with a space (" ") or a plus (" + "). Using a space as a separator does not work if any of the unit codes contains a space. For example, each of the following converts 1.2 km 2 to acres, square yards, and hectares.