Search results
Results From The WOW.Com Content Network
The Internet Engineering Task Force (IETF) has reserved the IPv4 address block 169.254.0.0 / 16 (169.254.0.0 – 169.254.255.255) for link-local addressing. [1] The entire range may be used for this purpose, except for the first 256 and last 256 addresses (169.254.0.0 / 24 and 169.254.255.0 / 24), which are reserved for future use and must not be selected by a host using this dynamic ...
A unique local address (ULA) is an Internet Protocol version 6 (IPv6) address in the address range fc00:: / 7. [1] These addresses are non-globally reachable [ 2 ] (routable only within the scope of private networks, but not the global IPv6 Internet).
Used for loopback addresses to the local host [1] 169.254.0.0/16 169.254.0.0–169.254.255.255 65 536: Subnet Used for link-local addresses [5] between two hosts on a single link when no IP address is otherwise specified, such as would have normally been retrieved from a DHCP server 172.16.0.0/12 172.16.0.0–172.31.255.255 1 048 576: Private ...
A special case of private link-local addresses is the loopback interface. These addresses are private and link-local by definition since packets never leave the host device. IPv4 reserves the entire class A address block 127.0.0.0 / 8 for use as private loopback addresses. IPv6 reserves the single address ::1.
IPv6 addresses are assigned to organizations in much larger blocks as compared to IPv4 address assignments—the recommended allocation is a / 48 block which contains 2 80 addresses, being 2 48 or about 2.8 × 10 14 times larger than the entire IPv4 address space of 2 32 addresses and about 7.2 × 10 16 times larger than the / 8 blocks of IPv4 ...
Once a unique link-local address is established, the IPv6 host determines whether the LAN is connected on this link to any router interface that supports IPv6. It does so by sending out an ICMPv6 router solicitation message to the all-routers [44] multicast group with its link-local address as source. If there is no answer after a predetermined ...
IPv6 hosts are required to support multiple addresses per interface; moreover, every IPv6 host is required to configure a link-local address even when global addresses are available. IPv6 hosts may additionally self-configure additional addresses on receipt of router advertisement messages, thus eliminating the need for a DHCP server. [2]
The Dynamic Host Configuration Protocol version 6 (DHCPv6) is a network protocol for configuring Internet Protocol version 6 (IPv6) hosts with IP addresses, IP prefixes, default route, local segment MTU, and other configuration data required to operate in an IPv6 network.