Search results
Results From The WOW.Com Content Network
Coupling can be deliberate as part of the function of the circuit, or it may be undesirable, for instance due to coupling to stray fields. For example, energy is transferred from a power source to an electrical load by means of conductive coupling , which may be either resistive or direct coupling .
The main disadvantage of this coupling method is that it causes some loss for the low frequency signals. However, for amplifying signals of frequencies greater than 10 Hz, this coupling is the best and least expensive method. It is usually applied in small signal amplifiers, such as in record players, tape recorders, radio receivers, etc.
There are a number of choices for the method of coupling the amplifier stages together. In the direct-coupled amplifier , as the name suggests, the stages are connected by simple conductors between the output of one stage and the input of the next This is necessary where the amplifier is required to work at DC, such as in instrumentation ...
Amplifiers are sometimes classified by the coupling method of the signal at the input, output, or between stages. Different types of these include: Resistive-capacitive (RC) coupled amplifier, using a network of resistors and capacitors By design these amplifiers cannot amplify DC signals as the capacitors block the DC component of the input ...
Background: The output coupling method of a vacuum tube amplifier generally serves two basic purposes: Negation (blocking) of high DC voltages in the output section to prevent a damaging flow of direct electric current through the loudspeaker.
In electronics engineering, frequency compensation is a technique used in amplifiers, and especially in amplifiers employing negative feedback.It usually has two primary goals: To avoid the unintentional creation of positive feedback, which will cause the amplifier to oscillate, and to control overshoot and ringing in the amplifier's step response.
Here the internal units or portions of the op-amp (like the input stage, voltage gain stage, and output stage) will be direct coupled and will also be used to set up the bias conditions inside the op-amp (the input stage will also supply the input bias to the voltage gain stage, for example). However, when two op-amps are directly coupled the ...
A direct-coupled amplifier [1] or DC amplifier is a type of amplifier in which the output of one stage of the amplifier is coupled to the input of the next stage in such a way as to permit signals with zero frequency, also referred to as direct current, to pass from input to output. This is an application of the more general direct coupling.