Search results
Results From The WOW.Com Content Network
The turn (symbol tr or pla) is a unit of plane angle measurement that is the measure of a complete angle—the angle subtended by a complete circle at its center. One turn is equal to 2π radians, 360 degrees or 400 gradians. As an angular unit, one turn also corresponds to one cycle (symbol cyc or c) [1] or to one revolution (symbol rev or r). [2]
Diagram of turning vehicle. On wheeled vehicles with the common type of front wheel steering (i.e. one, two or even four wheels at the front capable of steering), the vehicle's turning diameter measures the minimum space needed to turn the vehicle around while the steering is set to its maximum displacement from the central 'straight ahead' position - i.e. either extreme left or right.
In dance and gymnastics, a turn is a rotation of the body about the vertical axis. It is usually a complete rotation of the body, although quarter (90°) and half (180°) turns are possible for some types of turns. Multiple, consecutive turns are typically named according to the number of 360° rotations (e.g., double or triple turn).
A standard rate turn is defined as a 3° per second turn, which completes a 360° turn in 2 minutes. This is known as a 2-minute turn, or rate one (180°/min). Fast airplanes, or aircraft on certain precision approaches, use a half standard rate ('rate half' in some countries), but the definition of standard rate does not change.
A loop is when the pilot pulls the plane up into the vertical, continues around until they are heading back in the same direction, like making a 360 degree turn, except it is in the vertical plane instead of the horizontal. The pilot will be inverted (upside down) at the top of the loop.
An angle equal to 1 / 2 turn (180° or π radians) is called a straight angle. [10] An angle larger than a straight angle but less than 1 turn (between 180° and 360°) is called a reflex angle. An angle equal to 1 turn (360° or 2 π radians) is called a full angle, complete angle, round angle or perigon.
A degree (in full, a degree of arc, arc degree, or arcdegree), usually denoted by ° (the degree symbol), is a measurement of a plane angle in which one full rotation is 360 degrees. [4] It is not an SI unit—the SI unit of angular measure is the radian—but it is mentioned in the SI brochure as an accepted unit. [5]
Transfer table (UK: 'traverser') – provides access to two or more parallel tracks in a space saving manner like a turntable, but without the ability to turn. A Sector plate or sector table is a traverser that rotates around a pivot that is not at the centre and therefore cannot rotate through 360˚.