Search results
Results From The WOW.Com Content Network
Omnidirectional radiation patterns are produced by the simplest practical antennas, monopole and dipole antennas, consisting of one or two straight rod conductors on a common axis. Antenna gain (G) is defined as antenna efficiency (e) multiplied by antenna directivity (D) which is expressed mathematically as: =.
A competing third criterion is the number and bandwidth of the frequenc(y/ies) that a single antenna intercepts or emits. A fourth design goal is to make the antenna directional: To project or intercept radio waves from only one vertical and / or horizontal direction as exclusively as possible. Simple antennas
The J-pole antenna is an end-fed omnidirectional half-wave antenna that is matched to the feedline by a shorted quarter-wave parallel transmission line stub. [5] [1] [6] For a transmitting antenna to operate efficiently, absorbing all the power provided by its feedline, the antenna must be impedance matched to the line; it must have a resistance equal to the feedline's characteristic impedance.
The top shows the directive pattern of a horn antenna, the bottom shows the omnidirectional pattern of a simple vertical dipole antenna. In the field of antenna design the term radiation pattern (or antenna pattern or far-field pattern) refers to the directional (angular) dependence of the strength of the radio waves from the antenna or other ...
The latter factor is quantified by the antenna gain, which is the ratio of the signal strength radiated by an antenna in its direction of maximum radiation to that radiated by a standard antenna. For example, a 1,000 watt transmitter feeding an antenna with a gain of 4× (equiv. 6 dBi) will have the same signal strength in the direction of its ...
A reference antenna is an antenna with known performance. It is normally used to calibrate other systems. It is normally used to calibrate other systems. During a relative calibration, an antenna's phase center offset (PCO) and phase center variations (PCV) are computed with respect to the reference antenna which is normally assigned zero PCV ...
A batwing or super turnstile antenna is a broadcasting antenna used at VHF and UHF frequencies, named for its distinctive shape resembling a bat wing or bow tie. Stacked arrays of batwing antennas are used as television broadcasting antennas due to their omnidirectional characteristics. [1] Batwing antennas generate a horizontally polarized signal.
In its use as a television antenna, it was common to combine a log-periodic design for VHF with a Yagi for UHF, with both halves being roughly equal in size. This resulted in much higher gain for UHF, typically on the order of 10 to 14 dB on the Yagi side and 6.5 dB for the log-periodic. [ 5 ]